FreeCAD Route a Wire using Part WB and Sketcher @mathcodeprint
FreeCAD Route a Wire using Part WB and Sketcher @mathcodeprint
Uploaded September 2018 | Updated September 2026, 2 weeks ago
In response to suggestions from "The Steeds", I decided to do a quick video on routing wires using the Sketcher Workbench. This could also be done using draft wire ( and may in fact be better if you are going around a corner ). However the Draft workbench is a little harder to understand.
FreeCAD Route a Wire using Part WB and SketcherFreeCAD Quickie - Quick Demo of Draft MirrorOpenSCAD - Project Enclosure - Create round corners with Minkowski SumNew Awesome Videos - Houses and ToysBlender - Short Dominoes ClipFusion 360 Toy Brick - Beginner TutorialOpenSCAD - utility - explode() moduleTimeLapse - 3x2 LegoBlocksCAD - Blocks Based Programming a Printable BearingFreeCAD Assembly Tutorial - The new a2+ Workbench has arrived.Blender - Distracted DominoesMousetrap Car - 3d Printed
mathcodeprint |

FreeCAD Route a Wire using Part WB and Sketcher

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER