William Thielicke | FPV racing airplane: CAD design, 3D milling & maiden flight! @Willa1980 | Uploaded November 2017 | Updated October 2024, 3 hours ago.
I wanted to create a small FPV racing aircraft that has a good performance on small racing tracks with FAI gates. So I created this bimotor airplane. The yaw control makes it very agile. I am using a flight controller with iNAV firmware to stabilize all axes.
I like the results, and I am looking forward to fly it on race tracks with a lot of gates.
Setup:
Emax Femto FC
2x xnova 1407 3100 kV
4x4.5 2-blade Props
3x Savöx SH-0264MG Servo
4S 450 mAh - 1000 mAh Lipo
2x Emax Bullet 12A ESCs
Unify Pro Race VTX
Runcam Micro Swift
I wanted to create a small FPV racing aircraft that has a good performance on small racing tracks with FAI gates. So I created this bimotor airplane. The yaw control makes it very agile. I am using a flight controller with iNAV firmware to stabilize all axes.
I like the results, and I am looking forward to fly it on race tracks with a lot of gates.
Setup:
Emax Femto FC
2x xnova 1407 3100 kV
4x4.5 2-blade Props
3x Savöx SH-0264MG Servo
4S 450 mAh - 1000 mAh Lipo
2x Emax Bullet 12A ESCs
Unify Pro Race VTX
Runcam Micro Swift