Uploaded November 2018 | Updated September 2026, 11 hours ago
Swapping out your flowtoys club body, handle, knob or shaft? Here's how.
Minimize how often you replace the screw/knob. It is not intended to be swapped out frequently. While we have had success with 20+ replacements, it will eventually wear out the hole and the club will need to be sent in for servicing.
Please ONLY use the screw that comes with the flowtoys club knob - other screws may be too long and may drill through the circuit board and damage the top LED. Please note that we cannot warranty your board in full if this happens.
In order to maximize the amount of light near the knob, the screw is very short and can easily be stripped out. Please be careful to use great force when screwing the knob in (you read that right - use force). You should be pushing it in hard, while screwing so it does not act like a drill. Be sure to screw it in deeply/firmly, so it does not easily rip out during use.
===========================================
- Access the full flowtoys range of LED & day props at: flowtoys.com/props-category
- Learn more about flowtoys, our mission & design values: flowtoys.com/about-us
- Discover the stories behind the toys: flowtoys.com/toystories
- Enjoy reading the history of our small company: flowtoys.com/history
Swapping out your flowtoys club body, handle, knob or shaft? Here's how.
Minimize how often you replace the screw/knob. It is not intended to be swapped out frequently. While we have had success with 20+ replacements, it will eventually wear out the hole and the club will need to be sent in for servicing.
Please ONLY use the screw that comes with the flowtoys club knob - other screws may be too long and may drill through the circuit board and damage the top LED. Please note that we cannot warranty your board in full if this happens.
In order to maximize the amount of light near the knob, the screw is very short and can easily be stripped out. Please be careful to use great force when screwing the knob in (you read that right - use force). You should be pushing it in hard, while screwing so it does not act like a drill. Be sure to screw it in deeply/firmly, so it does not easily rip out during use.
===========================================
- Access the full flowtoys range of LED & day props at: flowtoys.com/props-category
- Learn more about flowtoys, our mission & design values: flowtoys.com/about-us
- Discover the stories behind the toys: flowtoys.com/toystories
- Enjoy reading the history of our small company: flowtoys.com/history
