Gregs Maker Corner | EZBoard Lite @GregsMakerCorner | Uploaded June 2019 | Updated October 2024, 7 hours ago.
This is a walkthrough of how I installed the TH3D EZBoard Lite control board for my CR10S printer. I was in the first batch of pre-orders and got an early copy. The EZBoard can be installed on a CR-10, CR-10S, Ender 3, Ender 5. It can run on both 12v and 24v.
My goal was to have a silent 3d printer. The CR10S is normally very loud. This is a great upgrade and made the printer much more quiet, to the point where I can only hear the fans running while printing.
Like this video? Great! If you are considering buying a TH3d board, please use my affiliate link. This will help me buy more stuff so that I can review it and make videos!
th3dstudio.com/product/ezboard-lite/?share=greg.huber&campaign=Greg'sMakerCorner-EZBoardLite
My CR10S has been upgraded, and I run a Titan Aero hot end on it. If you are running the stock hot end, you shouldn't run into any problems with the extruder or having to change steps, as I mentioned in the video.
Here are some other useful links:
The crimper kit that I used to make ferrules:
amazon.com/Ferrule-Crimping-Tool-Kit-0-08-10mm%C2%B2/dp/B07K17VDF2/ref=pd_lpo_sbs_469_t_1?_encoding=UTF8&psc=1&refRID=09SZEGAWQ9G6R2TGC4FK
TH3D Marlin 2.0 Firmware Info:
th3dstudio.com/knowledgebase/ezboard-installation-guide
Titan Aero:
printedsolid.com/products/e3d-titan-aero
This is a walkthrough of how I installed the TH3D EZBoard Lite control board for my CR10S printer. I was in the first batch of pre-orders and got an early copy. The EZBoard can be installed on a CR-10, CR-10S, Ender 3, Ender 5. It can run on both 12v and 24v.
My goal was to have a silent 3d printer. The CR10S is normally very loud. This is a great upgrade and made the printer much more quiet, to the point where I can only hear the fans running while printing.
Like this video? Great! If you are considering buying a TH3d board, please use my affiliate link. This will help me buy more stuff so that I can review it and make videos!
th3dstudio.com/product/ezboard-lite/?share=greg.huber&campaign=Greg'sMakerCorner-EZBoardLite
My CR10S has been upgraded, and I run a Titan Aero hot end on it. If you are running the stock hot end, you shouldn't run into any problems with the extruder or having to change steps, as I mentioned in the video.
Here are some other useful links:
The crimper kit that I used to make ferrules:
amazon.com/Ferrule-Crimping-Tool-Kit-0-08-10mm%C2%B2/dp/B07K17VDF2/ref=pd_lpo_sbs_469_t_1?_encoding=UTF8&psc=1&refRID=09SZEGAWQ9G6R2TGC4FK
TH3D Marlin 2.0 Firmware Info:
th3dstudio.com/knowledgebase/ezboard-installation-guide
Titan Aero:
printedsolid.com/products/e3d-titan-aero