Exploded View Bench @danthemakerman
Exploded View Bench  @danthemakerman
Uploaded May 2017 | Updated November 2026, 2 hours ago
Yes I cheated. I used 2x8s and not 2x4s actually they are 2x10s so I really went all out on the cheating. Originally I planned to use 2x4s but that would have made the bench too narrow or small and I didn't like the way the bench looked if I added more 2x4s across the top. So after a few sketches I decided to use the 2x10s instead.

Why do I call this the "Exploded View Bench"? While I was sketching this out I kept thinking about how to get good miters. My plan was to use the rebar as a dowel for the mitered corners but I kept thinking the miters where going to be a problem. I would most likely have gaps, I suck at miters. Instead of obsessing with it I just put it on the back burner and decided to figure it out when it came time to make the connection. Well since I suck at miters I didn’t take in to consideration the mitered cut when measuring the legs of the bench so I ended up cutting the legs too short. I was a little pissed for making the mistake and felt a little stupid too. Trying to figure out what to do I laid the cut pieces on the floor in the configuration that they would have been joined and measured the legs to see how bad I had screwed up. I started to pull the leg away from the top to get an idea of how bad I had screwed up. And it was at that moment that I had the thought. With the legs separate from the bench top it looked like an “exploded” view of a piece of furniture. It looked like the diagrams you see in manuals for how pieces are supposed to go together where all the individual pieces are separated from one another. My bench top and legs were already going to be made from two pieces with a gap running down the center so I decided to do the same with the mitered joints to keep them separated. Instead of worrying about the mitered gaps I was emphasizing them. This allowed me to get a little more height in the legs and in my eyes tie the whole design together. The gaps become a feature instead of a flaw. I could also be pretty loose with my cuts as I didn’t have to be very accurate since no two surfaces would actually need to touch. One issue I had to address was the lateral stress the bench would receive. Tthe legs couldn’t bear any side to side motion without breaking. So I decided to add some “L” brackets to give them some strength. I really like the way it turned out and I hope you enjoyed this video. Please feel free to ask any questions in the comments below.
Exploded View BenchResin Wand - Secret Wood Wand -  Inspired by Peter BrownIron Man Wall Art - Limited Tools - Making It YourselfMay the 4th be with you - Star Wars The Force Cap CatcherMaking It Yourself - The Sliver Kiridashi - Knife BuildA Damascus marking knife I recently made for an internet buddy of mine.  He provided the Damascus.Forged Feather Pen - No Lathe Pen ChallengeBlack Panther Comic Book Corner Art #laserengraver #marvel #comicbooks #lasercutting #blackpantherOklahoma University Logo - pallet wood DIYHow to Make a Marking Knife for Fine Woodworking JoineryWand/Pen.  I thought this would be a cool idea for making a wand that doubles as a pen.Packaging the Tools I Sell
Daniel Quiroz |

Exploded View Bench

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER