ESP32 Based SDR Transmitter - Part 3 BPF, Preamp and fixing some Amp problems @na5y
ESP32 Based SDR Transmitter - Part 3 BPF, Preamp and fixing some Amp problems  @na5y
Uploaded December 2022 | Updated November 2026, 3 days ago
This is the third video in the SDR transmitter series and in this video I move on to the bandpass filter after the Tayloe Encoder as well as building up a little preamp to raise the signal up to that required by the Amplifier. I don't get to installing the amplifier and LPF in this video but I do some troubleshooting with a broken QRP Labs 10W amplifier

Part 1 - youtube.com/watch?v=XdupkNW19kA
Part 2 - youtube.com/watch?v=yNxErsmimLY

Preamp board
github.com/thaaraak/tayloe-preamp

BPF board
github.com/thaaraak/double-tuned-bpf

QRP-Labs 10W Amplifier
qrp-labs.com/linear.html

0:00 Intro
01:04 Bandpass Filter Schematic
02:07 BPF Board populated
03:23 BPF on the Spectrum Analyzer
04:06 BPF installed after the Tayloe Encoder on the oscilloscope with single tone
04:55 Comparison to signal without BPF
05:37 Comparison with two tone test
06:20 A view on the spectrum analyzer
08:27 The amplifier I will be using
09:21 Oh oh - I broke the amplifier! Some troubleshooting
11:05 IRF510s pulled from board
11:37 More blown components found
12:52 Amplifier back working again and testing the output on the scope
14:44 A quick look at the input impedance of the Amplifier using the minivna
15:50 Preamp schematic
16:36 Preamp board
17:09 Preamp board populated and testing out of circuit
18:24 Preamp installed after BPF and tested
21:39 Wrapup and next steps
ESP32 Based SDR Transmitter - Part 3 BPF, Preamp and fixing some Amp problems70W Amplifier - Using RD16HHF1Magnis SDR - Part 7 Transmit MixerEnsemble RXTX Build #11 - Driver, Finals and TestingEnsemble RXTX Build #2 - 12V and 5V supplyNorcal Sierra - Part 6 Pre Mix OscillatorTinypico Radio Part 11 - Microphone AmpTinyPICO Radio Part 3 - Some ADC FunNight Landing at Logan, BostonESP32 IoT Radio - Part 3 Web InterfaceQRPGuys Paraset Regenerative receiver - Part 1a Transmitter Problem Fixed?Magnis SDR - Part 6 A Quick On the Air video
NA5Y |

ESP32 Based SDR Transmitter - Part 3 BPF, Preamp and fixing some Amp problems

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER