Uploaded September 2020 | Updated September 2026, 2 weeks ago
This is as far as im aware the official branded ender 3 glass build platform. It is cheap but not as cheap as getting glass cut but it was the only available option for me and so far I don't regret the switch too it less tape needed and less prep for me prints pop off when im done easy and stick great.
-----------------------------------------------------------------------------------------------------------
Some useful tips:
1. Use metal scraper to remove dust a light pass with scrapper before using microfiber cloth works great.
2. Salt water is great to clean with and help with adhesion. I rarely need to use it but it does work great if your out of rubbing alcohol.
3.Compressed air sprayed when bed is 45c to 50c upside down frees stuck prints quick and is safe. Also one part water one part alcohol or rubbing alcohol works good too for freeing prints.
4.When in doubt fridge it out. Putting glass in fridge is safe for short periods but wait for it to cool off before popping it in the fridge give it 5 to 15 min.
5.Changing build plate temp to 60c helps alot but I printed fine at default pla build plate temps of 50c before but I usually do 60c.
-----------------------------------------------------------------------------------------------------------
Get the glass ender 3 bed here " ebay.com/sch/i.html?_from=R40&_trksid=p2380057.m570.l1311&_nkw=ender+3+glass+bed&_sacat=0 "
-----------------------------------------------------------------------------------------------------------
Please Visit: " everythingdigital1.com "
This is as far as im aware the official branded ender 3 glass build platform. It is cheap but not as cheap as getting glass cut but it was the only available option for me and so far I don't regret the switch too it less tape needed and less prep for me prints pop off when im done easy and stick great.
-----------------------------------------------------------------------------------------------------------
Some useful tips:
1. Use metal scraper to remove dust a light pass with scrapper before using microfiber cloth works great.
2. Salt water is great to clean with and help with adhesion. I rarely need to use it but it does work great if your out of rubbing alcohol.
3.Compressed air sprayed when bed is 45c to 50c upside down frees stuck prints quick and is safe. Also one part water one part alcohol or rubbing alcohol works good too for freeing prints.
4.When in doubt fridge it out. Putting glass in fridge is safe for short periods but wait for it to cool off before popping it in the fridge give it 5 to 15 min.
5.Changing build plate temp to 60c helps alot but I printed fine at default pla build plate temps of 50c before but I usually do 60c.
-----------------------------------------------------------------------------------------------------------
Get the glass ender 3 bed here " ebay.com/sch/i.html?_from=R40&_trksid=p2380057.m570.l1311&_nkw=ender+3+glass+bed&_sacat=0 "
-----------------------------------------------------------------------------------------------------------
Please Visit: " everythingdigital1.com "
