RCModelReviews | Durafly Tomahawk FPV flight test (Runcam Swift 3 Micro camera) @RCModelReviews | Uploaded 6 years ago | Updated 2 hours ago
I didn't get an FPV flight test into the review video so here it is, better late than never. This thing was surprisingly stable given the strength of the wind today at higher altitudes. Not too slow and plenty maneuverable.
For this flight I fitted the 1000mAH Graphene battery from HobbyKing but the model required quite a bit of up-trim to fly level with the forward CG this produced. One cell in the battery I used was also bad but I still got nearly 8 minutes of flight time at relatively high throttle settings.
The Runcam Swift 3 Micro also put on a good performance in the very challenging lighting conditions. The dirt-bike area is about 500m-600m from where we were standing.
Model configuration:
- Durafly Tomahawk
- Runcam Swift micro 3 FPV camera
- Turnigy Graphene 1000mAH 4S battery
- AOMWAY Commander goggles/DVR
- BeeRotor Honeydrop antenna
I didn't get an FPV flight test into the review video so here it is, better late than never. This thing was surprisingly stable given the strength of the wind today at higher altitudes. Not too slow and plenty maneuverable.
For this flight I fitted the 1000mAH Graphene battery from HobbyKing but the model required quite a bit of up-trim to fly level with the forward CG this produced. One cell in the battery I used was also bad but I still got nearly 8 minutes of flight time at relatively high throttle settings.
The Runcam Swift 3 Micro also put on a good performance in the very challenging lighting conditions. The dirt-bike area is about 500m-600m from where we were standing.
Model configuration:
- Durafly Tomahawk
- Runcam Swift micro 3 FPV camera
- Turnigy Graphene 1000mAH 4S battery
- AOMWAY Commander goggles/DVR
- BeeRotor Honeydrop antenna
