Uploaded May 2022 | Updated September 2026, 2 weeks ago
DSTB1 is an open-source accelerator and AltRAM card for the Atari ST: github.com/dh219/DSTB
Having received reports of issues with the first release of DSTB1 on pre-STE hardware, I've picked up an STFM motherboard off eBay. In this video I take you through what's necessary to prepare one of these early STs for the accelerator card.
This video is kindly supported by PCBWay: pcbway.com
twitter.com/thetechnoshed
0:00 Introduction
1:24 Testing the new board
5:46 Chip removal briefing
10:17 PCBWay.com
10:50 Chip removal
12:19 Pin removal
16:59 Unplugging the holes
17:33 Soldering the new socket
19:19 Testing the new socket
24:18 Fitting & testing DSTB1
35:52 Outro
DSTB1 is an open-source accelerator and AltRAM card for the Atari ST: github.com/dh219/DSTB
Having received reports of issues with the first release of DSTB1 on pre-STE hardware, I've picked up an STFM motherboard off eBay. In this video I take you through what's necessary to prepare one of these early STs for the accelerator card.
This video is kindly supported by PCBWay: pcbway.com
twitter.com/thetechnoshed
0:00 Introduction
1:24 Testing the new board
5:46 Chip removal briefing
10:17 PCBWay.com
10:50 Chip removal
12:19 Pin removal
16:59 Unplugging the holes
17:33 Soldering the new socket
19:19 Testing the new socket
24:18 Fitting & testing DSTB1
35:52 Outro
![[B-Roll] External PSU: cable resistance tests](https://i.ytimg.com/vi/fdCPEAc5cwk/mqdefault.jpg "[B-Roll] External PSU: cable resistance tests
The first cable I built in my External PSU video wouldnt power my ST.
Did I get my calculations wrong? Is it a bad cable? Was someting else the problem? Was it all three?
@thetechnoshed
https://twitter.com/thetechnoshed
https://github.com/dh219")
