Uploaded May 2013 | Updated September 2026, 18 hours ago

---

Now that our parts are here from the last video and you are ready to setup things, lets go into the next video, the build!

My build is rather simple but I hope you can come up with a few good ideas or concepts from watching.

The big things to take to mind are:
1.) Mounting (place, bracing, orientation)
2.) Your signal (splitters, low pass, etc)
3.) Convenience (equipment that must be turned on, speakers, headphones, etc)

I'll try to cover this best I can with the quick filming I took and then sum up things in the end.

Hope you enjoy the video and thanks again to all those who had helped make this project happen.

My Parts:
Aura AST-2B-4 Pro Bass Shaker - amzn.to/10nA9jt
Dayton Audio SA70 Subwoofer Amplifier - amzn.to/12XcuZ6

Donations for future kick start projects:
viciouscomputers.com/?page_id=17

Smaller Parts Used:
16GA Speaker Wire for hookup
RCA Piggyback Cable to split signal from my NuForce HDP DAC Pre-Outs
Misc Screws from screw kit
Drill to drill holes
Liquid Nails Adhesive

Filming with NIkon D5100 and Halogen Lights