Winston Moy | DIY Electric Branding Iron - #82 [CNC] @WinstonMakes | Uploaded 7 years ago | Updated 5 hours ago
After discovering some shortcomings of my 5-in-1 branding iron from a couple weeks ago, I set out to make a more convenient branding iron for my projects. Also, I will not be offended if you are horrified by my brazing technique.
Material: 360 Brass
(Average) CNC Parameters: 350mm/min feed, 10k RPM, 0.17mm DOC
Electric Woodburning Tool - http://amzn.to/2lWGqbc
Borax-Based Powder Flux - http://amzn.to/2kLdYUV
Cu-P Brazing Rods - http://amzn.to/2lWyWF9
Support my videos: patreon.com/winstonmoy
After discovering some shortcomings of my 5-in-1 branding iron from a couple weeks ago, I set out to make a more convenient branding iron for my projects. Also, I will not be offended if you are horrified by my brazing technique.
Material: 360 Brass
(Average) CNC Parameters: 350mm/min feed, 10k RPM, 0.17mm DOC
Electric Woodburning Tool - http://amzn.to/2lWGqbc
Borax-Based Powder Flux - http://amzn.to/2kLdYUV
Cu-P Brazing Rods - http://amzn.to/2lWyWF9
Support my videos: patreon.com/winstonmoy