DIY Double Ended Chamfer Tool @HM-Projects
DIY Double Ended Chamfer Tool  @HM-Projects
Uploaded December 2022 | Updated November 2026, 3 hours ago
Here I make a double ended chamfer tool that uses TCMT110204 inserts. It can be done very quickly without a lot of setup work.

Edit: As Maxim pointed out (and I messed up in the video edit), a sharper relief was ground under the cutter / insert seat for interior chamfer. The tool will otherwise rub against the stock as you can hear in the video around 7:15. It should cut cleanly after grinding relief as shown subsequently.

#australianmachinist #lathe
DIY Double Ended Chamfer ToolRotary Table Fixture Plate Registration BossDIY ER40 Collet Chuck - Longer Run-Out TestELS v2 Electronic Leadscrew - External Taper FailSieg SX3 R8 spindle with SKF tapered roller bearings top and bottom. Good enough I reckon.ELS v2 Electronic Leadscrew - External Reverse TaperRobin Renzetti Dial Test Indicator Holder - The lazy machinists good enough version 😜Lathe Dial Indicator HolderThreading using Diagonal In-Feed with ELSCarriage Gibs and LockPrecision Turning on a Budget Lathe with Electronic LeadscrewELS v2 - Electronic Leadscrew Automated Turning
HM |

DIY Double Ended Chamfer Tool

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER