Uploaded December 2021 | Updated September 2026, 1 week ago

---

We're going to use the Maduino Zero 4G board to create an air quality and environment monitor that posts data to a Thingspeak dashboard using a mobile 4G network. The Maduino is a great all-in-one Arduino development board with built in 4G and GPS modules.

Check out the Makerfabs Zero 4G - bit.ly/3ysSyU6

ADDITIONAL INFORMATION
---------------------------------------------------
Visit my blog for the full write up and instruction links - the-diy-life.com/diy-4g-air-quality-and-environment-monitor-record-data-anywhere

PURCHASE LINKS
---------------------------------------------------
Makerfabs Zero 4G - bit.ly/3ysSyU6
Makerfabs Open Wind Station - bit.ly/3ymZAJQ
Grove Sensor Beginner Kit - amzn.to/31my42U
Breadboard - amzn.to/3lnrqAB
Breadboard Jumpers - amzn.to/3xFop3f
Machine Screws - amzn.to/3tVuBSc

Equipment Used
Creality Ender 3 V2 - amzn.to/3EPQZBQ
USB Power Meter - amzn.to/3GNCu2d
Dremel Soldering Iron - amzn.to/3GM04wd

Some of the above parts are affiliate links. By purchasing products through the above links, you’ll be supporting this channel, with no additional cost to you.

CHAPTERS
---------------------------------------------------
0:00 Intro
0:43 Maduino Zero 4G
2:07 Breadboard Setup
2:52 Sketch & Thingspeak
3:46 3D Printing A Case
5:28 Assembling The Monitor
6:28 Final Thoughts

If you've got any ideas for Raspberry Pi, Arduino, or other Electronics projects or tutorials you'd like to see, let me know in the comments section.

#makerfabs #maduinozero4g #thingspeak