YogiTech | Direct Drive Ender 3 PRO with Mellow BMG Wind extruder. @yogitech-3D | Uploaded January 2022 | Updated October 2024, 3 hours ago.
We will convert an Ender 3 pro Bowden setup into a direct drive system. We will use a Mellow Wind extruder and hotend.

*CORRECTION: Part cooling fan is not 4040 but 5050

-----------------------
☕If you would like to support this channel and this type of content, you can do so at the following link:
ko-fi.com/yogitech
-------------------------

Equipment
--------------------------
⭐Mellow Direct Drive extruder can be purchased from this link with everything included:
https://s.click.aliexpress.com/e/_AtsTXa

⭐Double-sided Heat-adhesive Tape
https://s.click.aliexpress.com/e/_97Y0YC

Since I only had the barebone SET1 from Mellow, I had purchased the parts separately from below links:

⭐Trianglelab Bi-Metal Heatbreak used in the video:
https://s.click.aliexpress.com/e/_AC7H76

⭐Trianglelab v6 Brass Heatblockused in video:
https://s.click.aliexpress.com/e/_97EURA

*The above are affiliate links. No extra cost to you; however, I do receive a small commission if you use them to complete an order.
--------------------------


Thingieverse
------------------------------
⭐Part cooling fan holder:
thingiverse.com/thing:4662109

⭐BLT probe adapter
thingiverse.com/thing:2759439/files
---------------------------------


TIMESTAMPS
00:00 Intro
01:37 Unboxing
02:29 Mellow Extruder inspection
03:09 Original Ender 3 extruder disassembly
04:30 Mellow Extruder assembly
09:21 Thermals
10:22 Software configuration
12:29 Printing