YogiTech | SUNLU T3 3D Printer Review. Get to know your "Terminator"! @yogitech-3D | Uploaded March 2023 | Updated October 2024, 41 minutes ago.
This is a in-depth review of the Sunlu T3 3D printer. We will take a look at what comes in the box, open up the printer and check the components used and evaluate the printer features.
-----------------
Equipment links (affiliate):
⭐ Sunlu T3 Printer:
Sunlu:
sunlu.com/products/terminator-3-fast-printing-fdm-3d-printer-up-to-250mm-s-32bit?sca_ref=2609119.7JOwEt2Kwg
Aliexpress:
https://s.click.aliexpress.com/e/_DERjRJP
-----------------
⭐ Sunlu PLA Fillament:
sunlu.com/products/pla-pla-plus-3d-filaments-1kg-2-2lbs-fit-most-of-fdm-printerpla-pla-plus-3d-filaments-1kg-2-2lbs-fit-most-of-fdm-printer?sca_ref=2609119.7JOwEt2Kwg
-----------------
☕If you would like to support this channel and this type of content, you can do so at the following link:
ko-fi.com/yogitech
--------------------
00:00 Introduction
00:54 Unboxing
01:29 Assembly
02:20 Hardware features
06:38 Tuning and setup
09:21 First Prints
11:14 Firmware update
12:51 Power cut recovery
13:14 Filament run out test
13:56 Final Thoughts
This is a in-depth review of the Sunlu T3 3D printer. We will take a look at what comes in the box, open up the printer and check the components used and evaluate the printer features.
-----------------
Equipment links (affiliate):
⭐ Sunlu T3 Printer:
Sunlu:
sunlu.com/products/terminator-3-fast-printing-fdm-3d-printer-up-to-250mm-s-32bit?sca_ref=2609119.7JOwEt2Kwg
Aliexpress:
https://s.click.aliexpress.com/e/_DERjRJP
-----------------
⭐ Sunlu PLA Fillament:
sunlu.com/products/pla-pla-plus-3d-filaments-1kg-2-2lbs-fit-most-of-fdm-printerpla-pla-plus-3d-filaments-1kg-2-2lbs-fit-most-of-fdm-printer?sca_ref=2609119.7JOwEt2Kwg
-----------------
☕If you would like to support this channel and this type of content, you can do so at the following link:
ko-fi.com/yogitech
--------------------
00:00 Introduction
00:54 Unboxing
01:29 Assembly
02:20 Hardware features
06:38 Tuning and setup
09:21 First Prints
11:14 Firmware update
12:51 Power cut recovery
13:14 Filament run out test
13:56 Final Thoughts