Cutting Rabbet Joint into Chine (Part 2) (Preview) Wooden Boat Restoration @brandotown
Cutting Rabbet Joint into Chine (Part 2) (Preview) Wooden Boat Restoration @brandotown
Uploaded March 2011 | Updated September 2026, 2 weeks ago
"How To" Wood Boat Restoration Series (Complete 20 Disc Set)
Available Here:
townsendboatworks.com/dvds_for_sale_wooden_boats_tutorails

townsendboatworks.com
This is a video showing how I layout and mill a rabbit joint into a newly installed mahogany chine. The rabbit joint is always 90 degrees to the bottom frames. The rabbit joint is needed to receive the inner and outer plys, or the bottom. The inner ply will be 1/4" marine plywood and the outer ply will be 1/2" solid mahogany planking with 3M 5200 between the two.
Cutting Rabbet Joint into Chine (Part 2) (Preview) Wooden Boat RestorationDelivering Chris Craft Capri (CLICK LINK BELOW TO STREAM HOW TO VIDEOS)Manual Log GrappleRaccoon in Dumpster Wooden Boat RestorationLaying Out and Taping Waterline on Chris Craft (Preview)How to Bleach, Stain & Build Varnish on Wood Boat (Preview) (CLICK LINK BELOW TO STREAM FULL VIDEO)Covered Lifting StationTime Lapse Carriage Wheel AssemblySharpening Plane Blades and Chisels Wooden Boat RestorationChris Craft Laminated Transom Bow (Preview) CLICK LINK BELOW TO BUY FULL LENGTH VIDEO (DVD 1)Plugging Old Screw HolesMoving Lifting Station with Kubota (CLICK LINK BELOW TO STREAM HOW TO VIDEOS)
brandotown |

Cutting Rabbet Joint into Chine (Part 2) (Preview) Wooden Boat Restoration

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER