Uploaded January 2026 | Updated November 2026, 5 days ago
If you started a model in the Part workspace and later realized it should be an assembly, this Autodesk Fusion walkthrough shows the quick way to convert your design without starting over. You will switch the file from Part design to Hybrid design, convert bodies into components, and then add an As-Built Joint so you can test motion (like a print-in-place hinge) directly in Fusion.
Along the way, you will learn how to display component colors, set a revolute joint, define joint limits (minimum and maximum), and drive the joint to explore different configurations. Finally, you will use Section Analysis to spot interference and get practical advice on when to stay flexible during early prototyping versus when to rebuild as a fully parametric component-based model.
In this video you will learn
- How to change Document Settings from Part to Hybrid
- How to create components from bodies automatically
- How to add an As-Built Joint and set it to Revolute motion
- How to set joint limits and preview the range of motion
- How to drive a joint and check clearance with Section Analysis
Chapters
00:00 Convert a Part design to an assembly workflow
00:12 Example: print-in-place phone holder hinge (two bodies)
00:23 Why components are not available in Part mode
00:38 Switch Document Settings to Hybrid design
00:49 Create components from bodies automatically
01:00 Inspect and display component colors
01:15 Add an As-Built Joint between components
01:28 Set the joint to Revolute and test movement
01:40 Set minimum and maximum joint limits
01:56 Flip limits and preview the joint motion
02:08 Drive the joint to explore configurations
02:21 Edit Section Analysis to check interference
02:36 Workflow tip: model first, convert when it gets complex
02:52 When to rebuild as a fully parametric component model
03:06 After prototypes: move to a proper parametric assembly
03:20 Wrap-up
#autodeskfusion
#fusion360
#cad
If you started a model in the Part workspace and later realized it should be an assembly, this Autodesk Fusion walkthrough shows the quick way to convert your design without starting over. You will switch the file from Part design to Hybrid design, convert bodies into components, and then add an As-Built Joint so you can test motion (like a print-in-place hinge) directly in Fusion.
Along the way, you will learn how to display component colors, set a revolute joint, define joint limits (minimum and maximum), and drive the joint to explore different configurations. Finally, you will use Section Analysis to spot interference and get practical advice on when to stay flexible during early prototyping versus when to rebuild as a fully parametric component-based model.
In this video you will learn
- How to change Document Settings from Part to Hybrid
- How to create components from bodies automatically
- How to add an As-Built Joint and set it to Revolute motion
- How to set joint limits and preview the range of motion
- How to drive a joint and check clearance with Section Analysis
Chapters
00:00 Convert a Part design to an assembly workflow
00:12 Example: print-in-place phone holder hinge (two bodies)
00:23 Why components are not available in Part mode
00:38 Switch Document Settings to Hybrid design
00:49 Create components from bodies automatically
01:00 Inspect and display component colors
01:15 Add an As-Built Joint between components
01:28 Set the joint to Revolute and test movement
01:40 Set minimum and maximum joint limits
01:56 Flip limits and preview the joint motion
02:08 Drive the joint to explore configurations
02:21 Edit Section Analysis to check interference
02:36 Workflow tip: model first, convert when it gets complex
02:52 When to rebuild as a fully parametric component model
03:06 After prototypes: move to a proper parametric assembly
03:20 Wrap-up
#autodeskfusion
#fusion360
#cad










