Uploaded October 2026 | Updated November 2026, 2 days ago
A few months ago, I found a Sunbeam SWF2000 7" twin window fan at the local thrift store. The Sunbeam unit is more or less the same as a Holmes HAWF2021 but with a different color scheme.
These fans are objectively not the best, but I like them a lot because they're extremely nostalgic to me. I consequently liked this Sunbeam one as well, I've never seen one under the Sunbeam brand before and I liked the color scheme.
When I attempted to clean it up, the blades were stuck on the shaft. The blade ended up breaking as I tried to remove it. I was extremely upset by this as I figured the chances of finding another one was slim to none.
Lo and behold, a few weeks later, The Number H (@Xyspade ) finds another one and gives it to me! It was much cleaner on the outside, but a sticky tar disaster on the inside.
I opted to take the blades from that fan, which were very difficult to clean, and put them into the original one I found. The original unit I found cleaned up exceptionally well -- it looks like new. Now it runs like new with the replacement blades.
I do have all the pieces of the blade that broke. It might be a fool's errand, but I'm going to try to repair it.
Work performed:
-Fully disassemble both units, including removing the side panel clips (very frustrating process).
-Remove blades from replacement unit, put broken blade parts and second original blade inside replacement unit for safe keeping.
-Clean the replacement blades.
-Clean the guards of the original unit.
-Clean the motors from the original unit.
-Lubricate the motors from the original unit.
-Sand down the shafts on the motors from the original unit to prevent the blades from getting stuck on again.
-Reassemble motors and install into original unit.
-Install replacement blades into original unit.
-Fully reassemble.
A few months ago, I found a Sunbeam SWF2000 7" twin window fan at the local thrift store. The Sunbeam unit is more or less the same as a Holmes HAWF2021 but with a different color scheme.
These fans are objectively not the best, but I like them a lot because they're extremely nostalgic to me. I consequently liked this Sunbeam one as well, I've never seen one under the Sunbeam brand before and I liked the color scheme.
When I attempted to clean it up, the blades were stuck on the shaft. The blade ended up breaking as I tried to remove it. I was extremely upset by this as I figured the chances of finding another one was slim to none.
Lo and behold, a few weeks later, The Number H (@Xyspade ) finds another one and gives it to me! It was much cleaner on the outside, but a sticky tar disaster on the inside.
I opted to take the blades from that fan, which were very difficult to clean, and put them into the original one I found. The original unit I found cleaned up exceptionally well -- it looks like new. Now it runs like new with the replacement blades.
I do have all the pieces of the blade that broke. It might be a fool's errand, but I'm going to try to repair it.
Work performed:
-Fully disassemble both units, including removing the side panel clips (very frustrating process).
-Remove blades from replacement unit, put broken blade parts and second original blade inside replacement unit for safe keeping.
-Clean the replacement blades.
-Clean the guards of the original unit.
-Clean the motors from the original unit.
-Lubricate the motors from the original unit.
-Sand down the shafts on the motors from the original unit to prevent the blades from getting stuck on again.
-Reassemble motors and install into original unit.
-Install replacement blades into original unit.
-Fully reassemble.










