Uploaded October 2026 | Updated November 2026, 4 minutes ago
Howdy all!
I've been sailing and so it's taking me longer than usual to finish editing. So this is a short update to let folks know what's going on.
I'm pushing hard now to launch in May, but when I had a chance to join @AcornToArabella for a passage down the east coast, I had to take it. ^_^
I'll be home in another week, and then I should finally get the video done (if not before then).
Howdy all!
I've been sailing and so it's taking me longer than usual to finish editing. So this is a short update to let folks know what's going on.
I'm pushing hard now to launch in May, but when I had a chance to join @AcornToArabella for a passage down the east coast, I had to take it. ^_^
I'll be home in another week, and then I should finally get the video done (if not before then).
![Ep. 87 - 2.0v; Did I Kill My Battery?
I had been running a parasitic drain test, and noticed the BMS on one of the 6 packs shut off. When I checked, one cell had dropped to 2.0v. Until now, I always thought that a cell dropping below 2.5v would be damaged.
Can I recover this battery?
Building a Good and Cheap Bench Power Supply (Ep. 7)
* https://youtu.be/8xxwoMir_f8
] Channels that have Helped Me;
* @ProjectBrupeg
* @OffGridGarageAustralia
* @AcornToArabella
* @BillCarlson
] Chapters
0:00 - Testing Batteries; Off-season Storage
1:07 - Uh, I’ve Got a Problem…
4:03 - A Message To Recent Subscribers
5:02 - Wait, Can The Cell be Saved?!
8:15 - Remembering How to use the iCharger X8
9:48 - A Rapid Recovery!
12:10 - A Kitty Interlude!
12:49 - Back to Recovery - Equalizing
16:47 - Can the iCharger X8 be a 24v BMS?
26:17 - A Brief Boat Interlude
27:24 - I Heard Back From Qishou (QSO)
30:03 - Getting the Quattro Back Online
33:43 - Rebuilding as a 48v Battery
35:52 - A Couple of Mistakes
37:55 - Bang! Sparks!
38:47 - Finally Charging Again
39:33 - Top Balancing Issues Ep. 87 - 2.0v; Did I Kill My Battery?](https://i.ytimg.com/vi/5NrrdUoaK3g/mqdefault.jpg)
![29,000 Lt/Hr (7,680 usg/Hr); Is It Enough? - Ep. 117
Learning from the loss of four different sail boats, I reworked my plans for the bilge pump setup on Mermaids Rest. Is it over the top? Maybe, maybe not.
Ive decided to install three pumps; two electric and a new manual pump;
2,000 GPH / 7,571 LPH - Primary Electric
4,000 GPH / 15,141 LPH - Emergency Backup Electric
1,680 GPH / 6,300 LPH - Manual
This video talks about why I made this choice, and covers the installation and initial testing of the two electric options.
] Patreon:
- https://www.patreon.com/c/TheDigitalMermaid
] Channels that have Helped Me;
* @ProjectBrupeg
* @OffGridGarageAustralia
* @AcornToArabella
* @BillCarlson
] References;
Ocean Cruising Club;
* https://www.oceancruisingclub.org/
Report on the loss of 3 sailing boats during the 2024 Newport Bermuda Race
* https://www.oceancruisingclub.org/home/news/2987
Abandonment of S/Y Gunga Din and Rescue by S/Y Desna
* https://www.ussailing.org/wp-content/uploads/2025/02/Gunga-Din-Inquiry-Report-1.pdf
The Sinking of the Yacht Solution, and the Rescue of her Crew by United States Coast Guard
* https://www.ussailing.org/wp-content/uploads/2025/02/Solution-Inquiry-Report.pdf
The Sinking of the Yacht Alliance, and the Rescue of her Crew by Yacht Ceilidh, Assisted by Yacht Banter
* https://www.ussailing.org/wp-content/uploads/2025/02/Alliance-Ceilidh-Banter-Inquiry-Report.pdf
Rule 1500~4000gph Manual / Performance
* https://www.xylem.com/siteassets/brand/rule/resources/manual/rule-standard-bilge-1500-4000-iom-950-0584a_rev_d.pdf
Ep. 100 - First Off-Shore Passage; Halifax to St. Johns
* https://www.youtube.com/watch?v=ck92gQWUJkg
Buying a Sailboat - Part 1 - Electric Sailboat Conversion (Ep. 30)
* https://youtu.be/lirIIsBJ7Ac?t=522
Duckbill Valve
* https://en.wikipedia.org/wiki/Duckbill_valve
Rule Manual (No check valve source)
* https://www.xylem.com/siteassets/brand/rule/resources/manual/rule-360-2000-standard-bilge-iom.pdf
My 3D Models
* https://makerworld.com/en/@digimer/upload
Draw.io (via google drive);
* https://drive.google.com/file/d/1nYw4l_bMVAKDXD9O1qqpmhFWi6oFRpcq/view?usp=sharing
Comparison of 18-8, 304 and 316 Stainless Steel
* https://marshfasteners.com/difference-18-8-vs-304-vs-316/
Fact Check! “ASTERIA’S FINAL VOYAGE” | GGR 2022
* https://goldengloberace.com/fact-check-asterias-final-voyage-ggr-2022/
ASTERIAS FINAL VOYAGE: The Rescue of Tapio Lehtinen | GGR 2022
* https://www.youtube.com/watch?v=1ERtotP-JRU
#GGR2022 Tapio and his team talk about WHY ASTERIA SANK?
* https://www.youtube.com/watch?v=M1T2FbFUsuA
* 22:58 is the start of why she might have sunk.
* https://youtu.be/M1T2FbFUsuA?t=1558
Other Channels Mentioned In This Video;
* @OceanCruisingClub
* @Goldengloberace
] Chapters
0:00 - Back in February; A Happy Surprise
2:39 - Taking Lessons From Other Tragedies
4:10 - A New Bilge Plan
6:04 - Preparing to Abandon Ship Before Setting Sail
8:16 - How Did I Get Lucky?
9:36 - April; Pulling The Old Manual Bilge Hose
10:45 - May; Pulling The Old 2000 GPH Pump
12:17 - New Wiring Going In!
16:21 - Notes on Wiring The New 2000 GPH Pump
18:03 - June; Mounting the 4000 GPH Pump
20:07 - I Drilled Through To The Lead Keel...
21:33 - How Am I Going To Fix This?
23:25 - Fixing The Unexpected Holes With Gflex 655
26:19 - Mounting The 4000 GPH Pump Base
28:05 - Replacing The 2000 GPH Pumps Hose
31:23 - Routing The New Hoses; Now and Later
32:21 - The Anti-Siphon Loop; How Duckbill Valves Can Save Your Boat!
33:50 - Madi Is Easily Entertained
35:02 - Splicing In The Anti-Siphon Loop
36:43 - Testing the 2000 GPH
37:01 - Routing the 2 Hose Under The Cabin Sole
38:49 - Removing The Heavy Old Exhaust Hose
40:09 - August; Installing The New Float Switch Plinth
43:19 - Why Dont Bilge Pumps Use Integrated Float Switches?
43:47 - Filling The Holes For The Plinth; Did I Hit A Void?
46:19 - What Next? Lets Wire The New Pump!
52:28 - Installing The Switch Plinth
53:47 - Wiring The Bilge Pump Control Panel
54:33 - New Filming Gear For Christmas?
55:30 - Lessons From The Sinking Of M/Y Asteria
57:15 - Finishing Up Wiring And Initial Electrical Test
58:40 - Ways To Make a 2 Anti-Siphon Loop
59:29 - Replacing The Old Through-Hull
1:02:36 - Routing The 2 Bilge Hose Under
1:03:52 - Time To Flood The Bilge
1:04:49 - Wet Test; Take 1! Nope
1:06:49 - Wet Test; Take 2! Kinda Sorta Success 29,000 Lt/Hr (7,680 usg/Hr); Is It Enough? - Ep. 117](https://i.ytimg.com/vi/5Pd5I3ySEqw/mqdefault.jpg)


![Raritan 1700 Anode Replacement - BaB
This is a stand-alone video that shows how to remove and replace the sacrificial anode in a Raritan 1700 series marine hot water tank.
Peter Knowles, Travels With Geordie
* @TravelsWithGeordie
] Patreon:
- https://www.patreon.com/TheDigitalMermaid
] Channels that have Helped Me;
* @ProjectBrupeg
* @OffGridGarageAustralia
* @AcornToArabella
* @BillCarlson Raritan 1700 Anode Replacement - BaB](https://i.ytimg.com/vi/660x9sfBT70/mqdefault.jpg)





