Casting and LIVE De-Molding of our Generator Core @HarmonyTurbines
Casting and LIVE De-Molding of our Generator Core  @HarmonyTurbines
Uploaded May 2025 | Updated September 2026, 22 minutes ago
Having only one shot to capture something on video can be stressful. You sure hope it turns out well because there are no DO-OVER's! Guys, the past several weeks here at Harmony have been leading up to setting the core for our own custom-built simplified axial flux generator -- in RESIN! We prepared, we poured, we waited... and then we recorded the de-molding of the resin core as it was happening, LIVE! How did it go? Check it out!

Our decision to build our own custom simplified axial flux generator was a necessary one. We've tested many off-the-shelf generators over the past year, hoping to find a quicker / easier answer, but ultimately making our own to fit our needs is the way to go. Creating our core brings us incredibly close to being able to test our generator with our scoops for the full Harmony Turbine effect!

Stay tuned as we finish the generator and begin testing it. We're SO close!

Invest in Harmony Turbines: startengine.com/harmony-turbines

Adobe Music License
ASLC-3E04F359-74B26E29C0
Casting and LIVE De-Molding of our Generator CoreHarmony Turbines Weekly Whirl 8From Large-Scale Energy Sources to Possibilities Closer to HomeWait... We dont need a charge controller?We turned it all around…and here’s what we found…Harmony Turbines Live SAF Generator Reveal!Harmonys SAF Generator now installed and LIVE!Running the bearings in for our MVP PrototypeA Bold Step ForwardHarmony Turbines Weekly Whirl 7Harmony Turbines Weekly Whirl 5What does the Most Expensive Piece of Scotch Tape look like?
Harmony Turbines |

Casting and LIVE De-Molding of our Generator Core

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER