Can You Spot the Banding? Two DTF Print Modes Compared @BCHTechnologies
Can You Spot the Banding? Two DTF Print Modes Compared  @BCHTechnologies
Uploaded September 2026 | Updated November 2026, 3 days ago
How does a DTF print at 720 × 1440 compare with 1440 × 1440?
Kevin runs both settings and takes a close look at subtle banding and white ink coverage.
The video starts with the RIP configuration and a 720 × 1440 print, described as fast mode. Kevin points out faint bands roughly one inch apart in that sample, then shows the 1440 × 1440 output for comparison.
He also calls attention to the film dragging on the desk during printing and comments on the amount of white ink being laid down. These observations give you more to check than resolution alone when comparing your own output.
This is a visual comparison from this setup, not a controlled diagnosis of the banding’s cause. The video does not show a pressed-shirt comparison or measured ink coverage.
Subscribe to BCH Technologies for practical DTF printing, printer repair, and troubleshooting videos. Visit BCHTechnologies.com for related parts and technical resources.Join this channel to get access to perks:
youtube.com/channel/UCwjOyyJTec5a5ZznioRSJIw/join

See the printing results from Kevin's small batch printer using AcroRip v11. This test highlights specific output performance.

This video documents a test run utilizing AcroRip v11 on an R2R printer setup. I examine the specific output issues encountered during the process, specifically focusing on how the software calculates drop size. You will see firsthand the wave effect that appears on the print about one inch apart, which provides insight into why precise software calibration matters for these machines.

I also walk through the settings used, including the specific EcoTank 1A050-0 beta configuration. Whether you are troubleshooting your own setup or curious about how software variables affect overall print quality, this demonstration offers a transparent look at the current limitations and quirks I am navigating with this hardware.

Subscribe for more practical printer testing breakdowns, and let me know in the comments if you have encountered similar calibration issues with your own equipment.
Can You Spot the Banding? Two DTF Print Modes ComparedHow to Spot a Real vs. Fake Epson Printhead #525ET-8550 DTF Conversion - Install V3 Dampers, White Ink System & MODHow to Replace Epson ET15000 Dampers: Full Step-by-Step GuideEpson ET-8550 Repair: How to Replace the CR Encoder Strip / Clear BeltThis Printhead Trick Saves Hundreds #money #printer #repairThe Emotional Reward of a Successful RepairUnboxing the BCH A3+ DTF Printer | Assembly, Setup, and First ImpressionsThis Black Ink-Soaked Epson ET-8550 Was Trash… Watch It Become a Powerful DTF PrinterDont throw away that clogged printer #DTFPrinting #printinghacks #519How to Fix Your Epson PF Timing Belt (Step-by-Step) #PrinterMaintenance #EpsonET8550 #535How to Test a QF1 Transistor for Printer Repairs
Kevin at BCH |

Can You Spot the Banding? Two DTF Print Modes Compared

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER