Uploaded January 2026 | Updated November 2026, 22 hours ago
Thank you to the sponsor of this video PCBWay!
pcbway.com
In this video, I build a dedicated Z80 CPU tester to help diagnose failed processors found during recent ZX81 and Spectrum repairs. This project focuses on identifying original NMOS versus later CMOS variants, which differ in power consumption, heat production, and undocumented behaviour.
The build uses a red PCB from PCBWay and includes an SMD resistor modification to fit a specific footprint. After assembly, I test various Z80s from my parts bins, identifying several dead chips and units with simple bent pins.
Important Note on the Current Jumper: The current jumper must be installed by default for the tester to function. While the instructions suggest removing it to measure current with a multimeter, the device will not run or show test activity without the jumper in place.
Tester Limitations: This tool primarily exercises address lines using a small test program. Some complex faults, such as issues with the HALT line or other specific inputs/outputs, still require advanced diagnostic tools like the Backbit Chip Tester Pro
Tester Github:
github.com/djtersteegc/z80-cmos-nmos-tester
Retro Hardware Discord:
discord.gg/fAdwFVWPRj
Support the Channel:
If you enjoy these deep-dive repairs and want to help me keep these old machines out of the landfill, consider supporting me on Patreon!
Patreon:
patreon.com/c/morefunmakingit
(Early access, behind-the-scenes, and our private Discord!)
Check out my other channel:
For more in-depth board repairs and "bits that go inside," head over to More Fun Fixing It:
youtube.com/@UCp_nZTSh3Pw6bkMztszyPmg
More Fun Website
morefunmakingit.co.uk
Thank you to the sponsor of this video PCBWay!
pcbway.com
In this video, I build a dedicated Z80 CPU tester to help diagnose failed processors found during recent ZX81 and Spectrum repairs. This project focuses on identifying original NMOS versus later CMOS variants, which differ in power consumption, heat production, and undocumented behaviour.
The build uses a red PCB from PCBWay and includes an SMD resistor modification to fit a specific footprint. After assembly, I test various Z80s from my parts bins, identifying several dead chips and units with simple bent pins.
Important Note on the Current Jumper: The current jumper must be installed by default for the tester to function. While the instructions suggest removing it to measure current with a multimeter, the device will not run or show test activity without the jumper in place.
Tester Limitations: This tool primarily exercises address lines using a small test program. Some complex faults, such as issues with the HALT line or other specific inputs/outputs, still require advanced diagnostic tools like the Backbit Chip Tester Pro
Tester Github:
github.com/djtersteegc/z80-cmos-nmos-tester
Retro Hardware Discord:
discord.gg/fAdwFVWPRj
Support the Channel:
If you enjoy these deep-dive repairs and want to help me keep these old machines out of the landfill, consider supporting me on Patreon!
Patreon:
patreon.com/c/morefunmakingit
(Early access, behind-the-scenes, and our private Discord!)
Check out my other channel:
For more in-depth board repairs and "bits that go inside," head over to More Fun Fixing It:
youtube.com/@UCp_nZTSh3Pw6bkMztszyPmg
More Fun Website
morefunmakingit.co.uk










