Build and Test of Leading Edge Slats for the Su-XR | Made out of Composites! @rene_rosentraeger

Build and Test of Leading Edge Slats for the Su-XR | Made out of Composites! @rene_rosentraeger

Uploaded September 2021 | Updated September 2026, 14 hours ago

If you like this video, you can support me by becoming my Patreon:
patreon.com/Rene_Rosentraeger

Or with a coffee :)
buymeacoffee.com/ReneRc

Or a donation on Paypal:
paypal.me/rrosentraeger

My Instagram
instagram.com/rene_rosentraeger
My Website:
composite-visions.de

Build and Test of Leading Edge Slats for the Su-XR | Made out of Composites!

Su-47 to Su-X VTOL | Composite Construction and Flight Test | Pt.4

Ender 5 S1 does amazing Lightweight Prints

3D Vector Nozzles RC STOL Jet

First Flight of 3D-Print Jet with New Slats and Landing Gear

How to optimize a 3D-Printable VTOL-Jet | JRM-01 Pt.7

3D Print Vector Nozzles moving | RC EDF Jet

That was close | Gear Suspension Timelapse

Full Story of Building the JRM-01 VTOL-Jet | 3D-Print RC Project

SU-XR vs. RC DRACO by Horizon Hobby | Slow Flight at Low Light

Leading Edge Slat | Test Flight and Aerodynamic Fine Tuning | Build Carbon Wing Fence

JRM-01V50 VTOL 3D-Printed VTOL RC-Jet | INAV Setup

René Rosentraeger |

Build and Test of Leading Edge Slats for the Su-XR | Made out of Composites!