First Flight of 3D-Print Jet with New Slats and Landing Gear @rene_rosentraeger

First Flight of 3D-Print Jet with New Slats and Landing Gear @rene_rosentraeger

Uploaded May 2023 | Updated September 2026, 3 hours ago

STLs on : rc-jetprint.de/en

If you wanna support this project, you can become my Patreon:
patreon.com/Rene_Rosentraeger

Or buy me a coffee :)
buymeacoffee.com/ReneRc

Support me on Paypal:
paypal.me/rrosentraeger

First Flight of 3D-Print Jet with New Slats and Landing Gear

How to optimize a 3D-Printable VTOL-Jet | JRM-01 Pt.7

3D Print Vector Nozzles moving | RC EDF Jet

That was close | Gear Suspension Timelapse

Full Story of Building the JRM-01 VTOL-Jet | 3D-Print RC Project

SU-XR vs. RC DRACO by Horizon Hobby | Slow Flight at Low Light

Leading Edge Slat | Test Flight and Aerodynamic Fine Tuning | Build Carbon Wing Fence

JRM-01V50 VTOL 3D-Printed VTOL RC-Jet | INAV Setup

RC Jet Vertical Take Off and Transition

3D Print RC Harrier Build and Maiden Flight

Lightweight Light Installation on RC-Jets using COB-LED

LWPLA 3D-Printing with the Artillery Sidewinder X2 | Full Review

René Rosentraeger |

First Flight of 3D-Print Jet with New Slats and Landing Gear