Build a Real Robot - Episode 9 - Motor Controllers Part 2 @Dronebotworkshop
Build a Real Robot - Episode 9 - Motor Controllers Part 2  @Dronebotworkshop
Uploaded May 2019 | Updated November 2026, 11 hours ago
In episode nine of the Build a Real Robot series we will build the Motor Controller board.


Full series at dronebotworkshop.com/build-a-real-robot


The motor controller is built! It has been constructed using two Arduino Nanos and is wired up and ready to test.

Today I will show you the schematic of the controller and also how I hooked everything up on a small piece of perfboard. I’ll also explain why I decided to use the Arduino Nanos instead of Pro Minis of ATmega328P chips.

Also, there was a bit of a foul-up in last weeks video, it ended way too soon. An editing error that I apologize for.

The error also prevented you from hearing a question I posed to you regarding a way of exchanging information about the robot project, as well as your own robot builds. I asked the question again at the beginning of this video, so please leave me your comments - I’d love to get your opinions.

Now that the controller is built it’s time to move on to the software. I’ll be showing you some sketches in the next episode.

Hope you enjoy the video!
Build a Real Robot - Episode 9 - Motor Controllers Part 2Arduino IDE 2.0 - Testing Release Candidate 3Using the Arduino Pro Mini & FTDIBuild the Gemma Translator: No Internet RequiredESP32 Guide 2024 | Choosing and Using an ESP32 BoardArduino Alvik Robot - Makers GuideWLED on ESP32 – Setup Guide (with Audio Reactive)Troubleshooting - What to do when it wont work!Build a Custom Servo Motor with a DC MotorSolving I2C Address Conflicts - TCA9548A I2C MultiplexerAnalog Feedback Servo Motor - Improved Servo PerformanceMultimeters -  The Complete Guide
DroneBot Workshop |

Build a Real Robot - Episode 9 - Motor Controllers Part 2

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER