Build a Real Robot - Episode 11 - Motor Coding @Dronebotworkshop
Build a Real Robot - Episode 11 - Motor Coding  @Dronebotworkshop
Uploaded May 2019 | Updated November 2026, 3 hours ago
In todays episode of the Build a Real Robot Series I will give you an update on the code for the motor controller.

Article coming soon! Full series at dronebotworkshop.com/build-a-real-robot

Just a brief update today.

The code for the motor controller is still in development, and as I program it I’m also writing some test routines to exercise the controller and the motors.

Right now the controller runs a test routine that runs a sequence:

Move the motors at a speed of 200 for a couple of seconds.
Reverses and moves again at the same speed.
Stops for two seconds.
Accelerates forward to a speed of 255
Runs for four seconds and then decelerates to zero
Waits fours seconds
Repeats the acceleration and deceleration, but in reverse
Stops

I’ll go over some of the code today, specifically the code that does the acceleration and deceleration and also the code that determines the specific I2C address used by the Arduino Nano.

I’ll also go over some of the considerations you need to pay attention to when connecting a USB cable to the Nano while the robot is powered up.
Build a Real Robot - Episode 11 - Motor CodingThe Arduino Family - Uno - Mega - Nano - Pro Mini -ATtiny85I2C Rotary EncoderXIAO ESP32-C5 - 5 GHz Wi-Fi IoT PowerhousePixy2 Camera - Image Recognition for Arduino & Raspberry PiWiFi Stepper Motor Controller with Web-based InterfaceESP32 Online Tools - No IDE Required!News from the Workshop (+ New Videos Coming Soon)Peltier Effect Cooling - Experiments with a Peltier Cooler Devicee Paper with Arduino and Raspberry Pi(AI-Designed) Dual Robot Arm Controller - Designing with AIESP32-CAM MicroSD Card - Saving images with the ESP32-Cam
DroneBot Workshop |

Build a Real Robot - Episode 11 - Motor Coding

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER