Uploaded November 2019 | Updated September 2026, 3 weeks ago

---

Today i'm going to show you how I made this bubinga and spalted maple box to hold a set of router bits. The box sides are milled to 1/2" and a 1/4" groove is routed for the top and bottom. Next I make the bit holder, cut the miters, resaw the spalted maple and glue up the box.

ENTER THE GIVEAWAY: simplecove.com/1314/bubinga-spalted-maple-router-box

Thanks to Bits and Bits for sponsoring this video. bitsbits.com coupon code SIMPLECOVE15 for 15% off your next order!

Bits included in the box: 530-cm500 1/2", Whiteside W-HC4122 3/8", 425-CM250 1/4", 425-CM125 1/8"

SimpleCove Offcuts Second YouTube channel: youtube.com/channel/UCqz73qowmLJabwpCi_MVQyA
Dustin Penner (DP Make Stuff): youtube.com/channel/UCi5vt68L_LY7SWnZeO1ky0w


Parts/Supplies used (Affiliate links below):
Spray Lacquer: amzn.to/2PxR6eB
Magnets: amzn.to/2Ccx4P3
Push Pads for Bandsaw: amzn.to/335BItS
Self Centering Drill Bits: amzn.to/2r3Xwbd
Flush Trim Saw: amzn.to/2N1ZjG9

#besseytriggergrip #bessey #simplybetter

--------------------------------
Help support what I do by buying a SimpleCove t-shirt! bit.ly/SCWoodworkingShirt
--------------------------------
Tools I Use (affiliate):
amazon.com/shop/simplecove
--------------------------------
See more projects like this on my website: simplecove.com
--------------------------------
Subscribe to my channel: youtube.com/channel/UCmlRWK6jRFi2No_gDBDjwow?sub_confirmation=1
--------------------------------
Follow me on Social Media:

Instagram: instagram.com/simplecove
Twitter: twitter.com/simplecove
Facebook: facebook.com/simplecove
Pinterest: pinterest.com/simplecove
--------------------------------
Sean Walker
PO Box 1502
Versailles, KY 40383