Breather and Bleeder Cloth @fibreglast
Breather and Bleeder Cloth  @fibreglast
Uploaded September 2014 | Updated November 2026, 3 hours ago
Click here to see this product on Fibreglast.com:
goo.gl/Cw3vmp—Binder-Free, Conforms Closely to Contours of Part

Within your vacuum bagging lay-up, this Breather/Bleeder drapes easily over your laminate, directly below your bagging film, to serve two key purposes.

As a breather, it allows for vacuum pressure to be applied evenly across the entire surface of the laminate. It also permits any gases released during cure to escape. Use the 4 oz. format (#579) for applications working under 40 psi. The 7 oz. format (#1779) can be used at higher pressure cycles (between 40 and 85 psi), and provides a lower amount of surface porosity.

When used as a bleeder, both varieties absorb excess resin applied during the lay-up process. Keep in mind, the 7 oz. will absorb more resin and may result in a dry part without careful control. Bleeder should be thrown away after use.

Both 4 oz. and 7 oz. are available in 60"-wide formats.
Breather and Bleeder ClothFiberglass Rollers & Squeegees: 3 Jobs They Do in a Wet LayupUSA Luge Workshop Moments with Fibre Glast Composite MaterialsMarine/Epoxy Fairing CompoundDuratec ProductsChavant AutoStyle Design ClayResin Mixing Sets & Starter KitsNylon Vacuum Bagging Film, Below 300°FPrepreg Unidirectional Carbon Fabric (9.0 oz)Nylon Vacuum Bagging Film, Above 300°F3/ Electric Z Project - Trunk6 Lb. Mix and Pour Foam: Polyurethane Foam for Plugs & Void Filling
Fibre Glast |

Breather and Bleeder Cloth

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER