bitt power factor 3 .wmv @woopyjump
bitt power factor 3 .wmv  @woopyjump
Uploaded November 2011 | Updated November 2026, 5 hours ago
After my pure theories about how i understand the BITT, I decided to make a test on the real life with my very crude fence wire core BITT

And i was amazed by the fact that there is 2 independant loads connected to independant (wirely but not magnetically ) secondary.

My guess was if i desconnect one of the load , the other load should receive its other power and light brighter.

But not at all

And further more, the current draw on the primary increases very little only arround 1 Ma, by lighting 2 loads at almost full brightness.

So my question how does this system operate ?

Is Thane Heins theory of the 2 secondaries working together to maintain or sustain the real power given from the pure reactive power from the primary , and that without reflecting back to the sayd primary true ????

Discussion at OU in trhe Dr Steven Jones thread

Good luck at all

Laurent
bitt power factor 3 .wmvLENR practical test with a magnet 4caduceus coil on slayer exciter 1.wmvcold fusion perhaps replication 4gegene replication 1plasmajet 1charging by induction approach 2.wmvelectricity from mass and air 1.wmvtesla boiling water experiment1.wmvplasma burning poweronepulse bouncer test 2.wmvcaduceus coil on delamorto 1.wmv
woopyjump |

bitt power factor 3 .wmv

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER