Uploaded April 2018 | Updated September 2026, 1 week ago
I flew a good portion of that pack with a bent prop. Not just a bent prop, an accordion bent prop and I barely even noticed it. Only thing that clued me in something was wrong was a tiny bit more propwash than normal.
Can't wait to bring you guys more info on the latest airbot stuff I am testing =D
I flew a good portion of that pack with a bent prop. Not just a bent prop, an accordion bent prop and I barely even noticed it. Only thing that clued me in something was wrong was a tiny bit more propwash than normal.
Can't wait to bring you guys more info on the latest airbot stuff I am testing =D

![Betaflight 3.2.1(stable) - How to Flash and Setup Your Quad! - [ How To Quad ]
As promised on my last video, here is the flashing & tuning guide on Betaflight 3.2.1 - this is a quick video, I am not going to go into a ton of detail on what each setting does and its historical provenance. I am just going to show you guys how I Flash and set up my quads before the maiden.
Tuning the quad is a whole separate matter and should be done out in the field after a couple test flights.
Hope this helps some of you out there and dont hesitate to drop a comment with questions and what not.
[ Video INDEX ] Use this section to skip ahead
3:31 - Set Board to DFU for FLASHING!
4:39 - Selecting Betaflight Firmware and Flashing
5:55 - Quadcopter Setup Screen
6:21 - Uart Ports Screen and Ports Setup
6:53 - Betaflight Configuration Screen
10:20 - Radio Receiver Setup Screen
10:57 - Betaflight Modes & Switches Tab
11:34 - Quadcopter Failsafe Settings
12:04 - Betaflight PID & Rates Setup Screen
13:10 - Betaflight Notch Filter Settings Screen
16:11 - Betaflight Motors Tab
16:30 - Blackbox Settings Screen
*** DISCLAIMER ***
I was made aware that the configurator was updated on Google Play as of this morning. I had already shot and edited the video, so I am not going to re-do it. Either way, if you run bleeding edge Betaflight ( daily builds ) its good to get in the habit of manually updating the configurator. If your configurator already says 10 then you are good to go. Betaflight 3.2.1(stable) - How to Flash and Setup Your Quad! - [ How To Quad ]](https://i.ytimg.com/vi/_o0h22OQUxc/mqdefault.jpg)

![FRSky F-Port Protocol - The SBUS Killer!! [ LOOSE VLOG ]
Hey guys! Finally got some time to do some research and bring you guys some fresh tasty info. Looks like FRSky is working on a new RX protocol to deliver RX Control and TELEMETRY over a single wire connection.
F-Port is structured much like SBUS is except it uses an uninverted signal - meaning you dont need to fuck around with inversion anymore to get stuff to work. You also get Telemetry and control out of a single port which is pretty awesome.
[ LINKS ]
Betaflight Install Instructions - http://bit.ly/2A0idrn
F-Port Spec Documentation - http://bit.ly/2jW76JL FRSky F-Port Protocol - The SBUS Killer!! [ LOOSE VLOG ]](https://i.ytimg.com/vi/bY9BnNLBz60/mqdefault.jpg)
![Flying From Your Car - Beginner to Advanced [ GIT GUD SERIES ]
As promised, I am back with a video on how I do my flying from the car. There is not much secret to it guys - just your normal everyday gear will do the job, its really more about being cogniscent of your range and of objects between you and the quad.
Hope you guys enjoy and if you have any questions just drop me a line! Flying From Your Car - Beginner to Advanced [ GIT GUD SERIES ]](https://i.ytimg.com/vi/bYEC7XHVby4/mqdefault.jpg)
![CL RACING F4 - Flight Controller Overview - [ REVIEW ]
Beaver FPV Just got in the new CL RACING F4S with all the new updates and goodies. If you are a fan of the show you know the CLRACING F4 has become my go-to FC because of its dependability, performance and ease of use.
The new CLRACING takes that a step further with Camera Control support, dedicated Uart inversion for telemetry and much more!
Check out the video for a full overview and comparison with the old CLRACING FC.
Dont forget to SUBSCRIBE for more awesome stuff like this!
[ LINKS ]
Buy CLRACING F4 from Beaver FPV - http://bit.ly/2ySrOQf
CLRACING F4 V2 Manual - http://bit.ly/2gPuiIa CL RACING F4 - Flight Controller Overview - [ REVIEW ]](https://i.ytimg.com/vi/cB2P00UdCxw/mqdefault.jpg)
![IS THIS THING ON?? [ HD FREESTYLE ]
Hey guys! I am back posting some HD footage - I finally managed to get the 6 Hyphy with F80 motors to tune properly and not give me so much jello.
This weekend I went out with the rig and flew over the snow, conservative flight - didnt really feel like leaving the comfort of my car to go fetch the drone and I had limited range on the taranis since I am inside a metal cage.
Hope you guys enjoy, I will be doing a lot more stuff with HD moving forward so hopefully its stuff you guys enjoy! IS THIS THING ON?? [ HD FREESTYLE ]](https://i.ytimg.com/vi/cGDulZweaAc/mqdefault.jpg)

![New Ground Station, Airbot, Butterflight & MORE! - [ LOOSE VLOG ]
Its been a few weeks since I had time to sit down so lets catch up on what I have been working on for the past month!
[ Butterflight Swag ] - https://teespring.com/stores/butterflight New Ground Station, Airbot, Butterflight & MORE! - [ LOOSE VLOG ]](https://i.ytimg.com/vi/haNSAhbCnm4/mqdefault.jpg)
![Last bits summer.. [ RACING? ]
Enjoying this unexpected little bit of nice weather to practice a bit of racing before the nasty winter settles in. Just improvised a track out of the terrain and actually had a blast. Using low trees as gates seems like great practices so I will definitely be back again =D Last bits summer.. [ RACING? ]](https://i.ytimg.com/vi/hf4B-_b1bTo/mqdefault.jpg)
![New Years Flight [ FPV FREESTYLE ]
Ripping the Hyphy 6 over the new years - way too friggin cold to fly too far from the car. About -30c which meant flight times were about 2 mins at the most and trudging through snow to go fetch a drone was not on my wishlist!
Enjoy! New Years Flight [ FPV FREESTYLE ]](https://i.ytimg.com/vi/kUXleNJD1XQ/mqdefault.jpg)