Automotive Weekly Waveform 11 - How Smart Ignition coils work and scope captures @ThePracticalMechanic
Automotive Weekly Waveform 11 - How Smart Ignition coils work and scope captures  @ThePracticalMechanic
Uploaded December 2020 | Updated November 2026, 3 hours ago
Automotive weekly waveform #11 will guide you through the process of scoping smart ignition coils. Smart ignition coil typically have the transistor as well as other electronics built into the coil.

WARNING!!! We are working with voltages up to 40,000 volts. Use caution for your safety and the safety of your scope. NEVER connect scope directly to the secondary ignition cables or the coil output.

For this test we will need a COP wand, a HT extension lead or a coin to get a secondary waveform. If using a coil simply put your scope into a 1 or 2 volt scale and touch your scope lead to a coin placed on top of the ignition coil. Some coils are heavily shielded and will require the coil to be removed and a HT extension lead placed between the coil and the spark plug.

For scoping the logic level signal from the PCM to the coil we just need a standard scope lead. This signal is normally just a square wave between 0-5 volts or 0-12 volts. the IGT signal was 0-4 volts on this 2007 Toyota Highlander Hybrid.

You cannot scope the Primary voltage but you can scope the primary amperage by placing a low amp clamp around the power feed to the coils.

My toyota also had a feedback signal to the computer known as IGF. This wire is interconnected between all coils and get pulled to ground when each coil wants to let the PCM know that it received the IGT signal and is charging up.


facebook.com/groups/automotiveweeklywaveforms

affiliate link used below help support the channel at no addition cost to you. Thank you
Hantek HT308 COP Extension Cord with Earth Cord - amzn.to/3nEXfUk
60 amp PDI low amp clamp with banana plugs- amzn.to/3qznAW0
Cheaper hantek low amp clamp(I have never used this clamp) - amzn.to/2JwUC8x
20:1 attenuator - amzn.to/2JSicwl
10:1 attenuator for uscope - aeswave.com/Primary-Ignition-Probe-for-the-uScope-p9557.html
back probing set - amzn.to/3587E46
secondary ignition pickup(we will need this shortly) - amzn.to/35bxlkm
Automotive Weekly Waveform 11 - How Smart Ignition coils work and scope captures2000 Toyota Tundra Flashing 4x4 Light Diagnose and Repair - Actuator fixSubaru FlashWrite Programming Interface Showdown1960 Chevy Biscayne LS Swap - Ep 26 Aluminum Radiator install.Weekly waveform 11 recap - Smart ignition coils and more ignition comparisonWeekly waveform 7 recap - VR sensorsMake a tool challenge - Mechanical home made tool2013 Ford F150 Key Shell Replacement - No Programming RequiredLaunch Creader CR3008 Plus - Generic scan toolTopdon TB6000Pro battery tester, charger and maintainerAWW17 - analog MAF sensor voltage test2014 tundra Hard start or long crank time - TSB PCM update
ThePracticalMechanic |

Automotive Weekly Waveform 11 - How Smart Ignition coils work and scope captures

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER