AWW17 - analog MAF sensor voltage test @ThePracticalMechanic
AWW17 - analog MAF sensor voltage test  @ThePracticalMechanic
Uploaded March 2021 | Updated November 2026, 3 hours ago
This quick MAF sensor voltage test is a good way to verify the power, ground and signal to and from an analog Mass Air Flow sensor. You should check these signal whenever you have a p0101, p0102 or other MAF signal low code just to verify the sensor is able to produce a good signal. Most MAF signal are a 0-5v signal so a 5 or 10 volt scale will work bests. We don't need super high sample rates for this test and a 1 second sweep time on the snapon scope works well. the picoscope can be set to a 1sec/div for most quick test but if you are testing driving the vehicle a 10sec/div may work better.

For those that don't use FB and still want to submit waveforms you can email them here AWW@thepracticalmechanic.com
or fill out the form here
https://forms.gle/95mFpmnXevgV2JmX7
AWW17 - analog MAF sensor voltage test2014 tundra Hard start or long crank time - TSB PCM updateSubaru TR580 Valve Body testing TCC solenoid Fault and PCM/TCM updatesProDemand Basics for New Technicians or Learn a New Workflow2004 BMW 325i Front struts and control arm bushingsSnapon Triton D10 trigger feature.  Works on other Snapon scan tools.1960 Chevy Biscayne LS Swap Ep. 31 - Coil Cover problems2008 Subaru Impreza All keys lost - Pick, decode, cut and program1960 Chevy Biscayne LS Swap Ep 24 Wiring updateBiscayne LS Swap Test Drive and Wrap upWeekly waveform 19 recap- Throttle position sensorsTechline Connect with Launch Smart link j2534
ThePracticalMechanic |

AWW17 - analog MAF sensor voltage test

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER