Uploaded January 2025 | Updated November 2026, 10 hours ago
A few ways of creating a variable chamfer.
Link to Reddit post:
reddit.com/r/Fusion360/comments/1hthjyx/is_a_variable_chamfer_possible
Link to starting file:
a360.co/3WdP2df
If you have found this video useful and would like to support me, you can buy me a coffee at
buymeacoffee.com/fusion360school
or you can also support me on Patreon at
patreon.com/fusion360school?fan_landing=true
Disclosure: Autodesk has kindly sponsored the full version of Fusion that is used to produce the videos on this channel. That being said, Autodesk has no editorial control over the content on this channel. I am still an independent creator with the aim of creating videos that help viewers in using Fusion.
#autodeskad
#fusion360school
0:00 Intro
0:21 Taper during extrude
1:04 Draft
2:15 Surfacing
4:29 Start with a fillet
6:22 Ruled surface
7:47 Sweep
9:05 Re-odering of operations
A few ways of creating a variable chamfer.
Link to Reddit post:
reddit.com/r/Fusion360/comments/1hthjyx/is_a_variable_chamfer_possible
Link to starting file:
a360.co/3WdP2df
If you have found this video useful and would like to support me, you can buy me a coffee at
buymeacoffee.com/fusion360school
or you can also support me on Patreon at
patreon.com/fusion360school?fan_landing=true
Disclosure: Autodesk has kindly sponsored the full version of Fusion that is used to produce the videos on this channel. That being said, Autodesk has no editorial control over the content on this channel. I am still an independent creator with the aim of creating videos that help viewers in using Fusion.
#autodeskad
#fusion360school
0:00 Intro
0:21 Taper during extrude
1:04 Draft
2:15 Surfacing
4:29 Start with a fillet
6:22 Ruled surface
7:47 Sweep
9:05 Re-odering of operations










