Uploaded December 2016 | Updated September 2026, 5 hours ago

---

Hi Guys this is Part 1 of printing project T-REX skeleton with my Anet A8 3D Printer.
Settings in Cura 0.1mm 25% infil 35mm/s extruder speed with brim check.
Takes around 25 hours to print.
0.1mm,25%infill 150% scale
Here is link of T-rex
thingiverse.com/thing:275091

If you want to purchase this 3D printer here is link:
Anet A8 EU plug: goo.gl/kCzYvN

Anet A8 US plug: goo.gl/34WWUX

E3D V6 Hotend upgrade goo.gl/xbjjL5

GearBest.com -- goo.gl/pqKf6h
Banggood.com -- goo.gl/9CpYMJ
Aliexpress.com -- goo.gl/C8ndaT

3D printers parts and supplies goo.gl/NXVL7M

Cheap filaments
PLA filament goo.gl/D9jY9v
ABS Filament goo.gl/DBL1ok
Flexible filament -- goo.gl/1DMTJf

Premium/special quality filaments
APRINTAPRO shop goo.gl/sgXkAW

PrintaFix adhesion SPRAY goo.gl/Fr9tmU

Heat bed mosfet module -- goo.gl/91i7bQ

3D printing surface:
Sticker: goo.gl/WTmmiM
Glass: goo.gl/3GqP6Z
BueTape: goo.gl/7vQMYp

Switch for PSU goo.gl/sKzzkg

Rubber Timing Belt goo.gl/3xtQPv

SCS8UU-8mm-Linear-Ball-Bearing goo.gl/88pgGV

Insulation material: goo.gl/5Qbtve

Micro SD To SD Card Extension Cable goo.gl/zgKzrz


Please like and subscribe to my channel to help me making more videos.
Thank you so much for your support.
Best Regards
Nexi