AMS Nearly Empty Spool Problem @dwuk3d
AMS Nearly Empty Spool Problem  @dwuk3d
Uploaded November 2023 | Updated November 2026, 3 hours ago
Some video analysis the problem I sometimes have when spools get nearly empty.

I think it is caused by a combination of occasionally the roller gear - when is meant to only be engaged for unloads getting engaged for loads.

This stops the roller from spinning freely - and spins it a bit slow for nearly empty spools - that spin faster than fuller spools due to the fact that the filament that is pulling them creates more revolutions when spools are nearly empty
AMS Nearly Empty Spool ProblemSnail 10xSovol SV08 duet parallel IDEX - independent head movementDuet Parallel INDX Voron  3 -  basic operating modesSV08 Phase 2 1  Triple MovementHow much faster is a 0.8mm Nozzle than 0.4?SV08 INDX up down and around3d printed eight ball demoSovol SV08 Idex   Phase 1 Part 5   Auto AlignmentAnother Triple Sovol SV08Claude Simple 2d AnimationPrusa CoreOneL Bondtech INDX
David Wood (dwuk3d) |

AMS Nearly Empty Spool Problem

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER