Uploaded April 2026 | Updated November 2026, 2 hours ago
First DPIV3 post SMRRF26 demo.
First proper video of my SMRRF machine parallel printing with the two INDX tool heads installed. - the toolheads are I believe a few versions older than the final version that will hopefully be released shortly.
Hardware and original brief for the machine provided by Duet3d.
The electronics are also quite old, and use separate tool boards - probably similar to the electronics used at Formnext25 I imagine - not the final Duet / Prusa electronics that will be provided with the founders edition.
The demo uses RRF macros I created independently from Bondtech - based on early Beta Test (Oct25) Klipper macros.
I suspect other work is going on with closer involvement from Bondtech on the Klipper and hopefully RRF macro's that will be released with the founders edition.
The demo shows some parallel printing and the first stages of parallel pre-heat and priming - but a fair bit of work is required to get the timing correct to allow for sub second tool swaps between the two tool heads.
Whilst the demo shows the secondary toolhead printing - the primary intention for this toolhead is to support the Trident toolhead - by doing things like background tool rack management, pre heating and AMS/Box Turtle colour changes.
You can following this project either on the Duet Community Forum
forum.duet3d.com/topic/38917/duet-voron-trident
The Voron Discord
discord.com/channels/460117602945990666/1467940422935646308/1490390217155150059
Or this YouTube channel
First DPIV3 post SMRRF26 demo.
First proper video of my SMRRF machine parallel printing with the two INDX tool heads installed. - the toolheads are I believe a few versions older than the final version that will hopefully be released shortly.
Hardware and original brief for the machine provided by Duet3d.
The electronics are also quite old, and use separate tool boards - probably similar to the electronics used at Formnext25 I imagine - not the final Duet / Prusa electronics that will be provided with the founders edition.
The demo uses RRF macros I created independently from Bondtech - based on early Beta Test (Oct25) Klipper macros.
I suspect other work is going on with closer involvement from Bondtech on the Klipper and hopefully RRF macro's that will be released with the founders edition.
The demo shows some parallel printing and the first stages of parallel pre-heat and priming - but a fair bit of work is required to get the timing correct to allow for sub second tool swaps between the two tool heads.
Whilst the demo shows the secondary toolhead printing - the primary intention for this toolhead is to support the Trident toolhead - by doing things like background tool rack management, pre heating and AMS/Box Turtle colour changes.
You can following this project either on the Duet Community Forum
forum.duet3d.com/topic/38917/duet-voron-trident
The Voron Discord
discord.com/channels/460117602945990666/1467940422935646308/1490390217155150059
Or this YouTube channel










