AM Oscillator Test Using A Radio @OldSchoolElectronics
AM Oscillator Test Using A Radio  @OldSchoolElectronics
Uploaded January 2018 | Updated September 2026, 1 week ago
Test I learned a long time ago. In the video I set the suspected bad radio to the AM frequency of 600 kHz. The IF frequency in this case is 455 KHz. Both added together equal 1055 kHz. I then tuned the good radio to around 1055 KHz so I could pick up the radiated signal from the suspected bad radio. It is often necessary to bring the antenna of the good radio close to the oscillator section of the suspected bad radio in order to get a response.
AM Oscillator Test Using A RadioBasic testing of an optocoupler.Pioneer SX-440 Output Capacitor Square Wave TestSpray Can Extension   Contact Cleaner or OilHeathkit IT-28   Part2   Component Testing Of The UnitTone Control Testing of Pioneer SX-590 With AC VoltmeterFrequency Response Testing Of A Vintage Stereo ReceiverLoudness Control TestingTesting Pioneer SX-590 Tone Controls With Square WavesAkai AA-1010 Stereo Receiver Idling Current AdjustmentAudio Generator Voltage Output Check (with oscilloscope)Pioneer SX-525 Stereo Receiver Bulb (Lamps) Replacement
Old School |

AM Oscillator Test Using A Radio

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER