Uploaded September 2025 | Updated September 2026, 1 week ago
First, this is very long, Sorry....
THIS IS HOW I DO IT... Use of how I do this at YOUR OWN RISK!!!!!
I did not post pics about magnetic gauss, sorry.
This is just how I was taught to set up mod motors for a Clod (or other dual motor trucks that use a reverse rotational motor)
People have asked if you zero the timing, can I swap motor leads then? I guess you can, like on a stock Clod motor were you plug the rear yellow wire (positive) into the Neg side (blue wire) of the esc.
To me, its un-natural, pos is pos and neg is neg.. And when using an old school esc like a Tekin (Tea-Kin) Titan or Novak Super Rooster, we just run red to pos & black to neg. smarter & safer in my eyes.
The body is not fully painted but almost done..
I use full bearings & Robison Racing 13 steel pinions.
For James. @yodadarksideGreenHawksRC
Go check him/them out... Sub the channel
Well, that's it I think..
Any questions, feel free to ask.
Got a comment, say it... Good or bad..
Got another way or tip(s), tell us...
Thanks Guys.... See you on the next video
First, this is very long, Sorry....
THIS IS HOW I DO IT... Use of how I do this at YOUR OWN RISK!!!!!
I did not post pics about magnetic gauss, sorry.
This is just how I was taught to set up mod motors for a Clod (or other dual motor trucks that use a reverse rotational motor)
People have asked if you zero the timing, can I swap motor leads then? I guess you can, like on a stock Clod motor were you plug the rear yellow wire (positive) into the Neg side (blue wire) of the esc.
To me, its un-natural, pos is pos and neg is neg.. And when using an old school esc like a Tekin (Tea-Kin) Titan or Novak Super Rooster, we just run red to pos & black to neg. smarter & safer in my eyes.
The body is not fully painted but almost done..
I use full bearings & Robison Racing 13 steel pinions.
For James. @yodadarksideGreenHawksRC
Go check him/them out... Sub the channel
Well, that's it I think..
Any questions, feel free to ask.
Got a comment, say it... Good or bad..
Got another way or tip(s), tell us...
Thanks Guys.... See you on the next video
