FeedbackLoop | #51 - Datron 1071 display replacement part 2 @feedback-loop | Uploaded 7 years ago | Updated 23 hours ago
In this part a replacement display module and a controller board were built and installed. Since more pins were needed to drive five displays, ATMega164PA was used with the MightyCore library for Arduino IDE to support it. The result is not very good. The displays are not very bright, the brightness differs from display to display, and the viewing angle is quite limited. Suggestions for better displays for a reasonable price are welcome.
Forum: http://www.eevblog.com/forum/metrology/datron-1071-repair/
Repair video: https://youtu.be/jcCC867gKXE
Display replacement part 1: https://youtu.be/H9_Jwy-2vXU
Arduino MightyCore: https://github.com/mcudude/MightyCore
TFT ST7735 library: https://github.com/sumotoy/TFT_ST7735/tree/1.0p1
Snap fasteners: https://www.mcmaster.com/#93040A112
In this part a replacement display module and a controller board were built and installed. Since more pins were needed to drive five displays, ATMega164PA was used with the MightyCore library for Arduino IDE to support it. The result is not very good. The displays are not very bright, the brightness differs from display to display, and the viewing angle is quite limited. Suggestions for better displays for a reasonable price are welcome.
Forum: http://www.eevblog.com/forum/metrology/datron-1071-repair/
Repair video: https://youtu.be/jcCC867gKXE
Display replacement part 1: https://youtu.be/H9_Jwy-2vXU
Arduino MightyCore: https://github.com/mcudude/MightyCore
TFT ST7735 library: https://github.com/sumotoy/TFT_ST7735/tree/1.0p1
Snap fasteners: https://www.mcmaster.com/#93040A112