4 EQ Tricks for Comms Audio |  #audioengineering #audiotechnique #mixingvocals @Patchd-Studio
4 EQ Tricks for Comms Audio |  #audioengineering #audiotechnique #mixingvocals  @Patchd-Studio
Uploaded October 2026 | Updated November 2026, 2 days ago
A wall, an old phone line, a megaphone and a walkie-talkie each cut off a different part of your voice. That's why your voice sounds different through each one.

THE NEXT ROOM
A wall stops a lot more of the high sounds in your voice than the low sounds. What gets through is mostly 100 to 400 hertz, the body of your voice, and very little of 1,500 to 5,000 hertz, the part that makes your words clear. That's why a voice through a wall sounds muffled. To make it, use a low-pass filter around 450 hertz: it turns down everything higher than that.

AN OLD PHONE
A classic phone line only carries about 300 to 3,400 hertz. Below 300 is cut off, so you sound thinner, but most of the part that makes your words clear still fits inside the line, so you can still be understood. To make it, cut everything below 300 hertz and everything above 3,400.

A MEGAPHONE
A handheld megaphone's speaker can't play much below about 500 hertz, so most of the body of your voice is gone and you sound thin. To make it, cut everything below 500 hertz.

A WALKIE-TALKIE
A two-way radio sends about 300 to 3,000 hertz, a little less on top than a phone line. Before it sends your voice, a limiter turns down the loudest parts, so your voice never gets louder than the radio is allowed to send. To make it, cut below 300 and above 3,000, then add drive to flatten your loudest parts.

So to make your voice sound like it's coming through one of these, cut off what that thing cuts off: the top for the next room, both ends for a phone, more of the bottom for a megaphone, and both ends plus the loudest parts for a walkie-talkie.

The low-pass filter is free in Patchd's mixer, and Comms, one of Patchd's Studio effects, does the other three: its Lo and Hi set where it cuts, and its Drive flattens the loudest parts. Link in bio to get Patchd.

#audioengineering #voiceeffects #sounddesign #streamingtips #contentcreator #eq
4 EQ Tricks for Comms Audio |  #audioengineering #audiotechnique #mixingvocalsPeak Meter is not a Loudness MeterA Flanger inst a whoosh... heres what it actually doesHow a Vocoder worksStop Music From Covering Your VoiceYoure ordering your plugins wrong #audio #mixing #producerYou Can Actually Hear A Smile | Research Shows[Beginner Guide] How To Install Plugins and Pages on Touch PortalThe Easiest Virtual Mixer Setup on WindowsOne delay, seven secret effects #audioengineering #musicproductionBitcrush removes bit depth qualityReverb types are named after real sounds
Patchd Studio |

4 EQ Tricks for Comms Audio | #audioengineering #audiotechnique #mixingvocals

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER