skmetal7 | 3d toolpath manifold @skmetal7 | Uploaded 14 years ago | Updated 6 hours ago
4600rpm 14ipm 3 flute ball endmill. here you can see how the contour was cut. i needed a way to hold the part down, so i used 3 of the 6 holes in the part. i previously drilled and tapped the 3 points before placing the stock, (luckily) they lined up and the part didn't move between mounting transitions.
my camera battery was going dead, or i would have made it longer. all programmed in mastercam x
4600rpm 14ipm 3 flute ball endmill. here you can see how the contour was cut. i needed a way to hold the part down, so i used 3 of the 6 holes in the part. i previously drilled and tapped the 3 points before placing the stock, (luckily) they lined up and the part didn't move between mounting transitions.
my camera battery was going dead, or i would have made it longer. all programmed in mastercam x
