3D printing - Better bottom fillets with the Chamfillet technique @loughkb
3D printing - Better bottom fillets with the Chamfillet technique  @loughkb
Uploaded January 2025 | Updated November 2026, 3 days ago
I'm sure it's not an original idea, but I haven't seen anyone talk about it yet, so here you go. A hybrid chamfer/fillet that makes for cleaner bottom edges.

If you like my videos, please subscribe here:
http://www.youtube.com/user/loughkb?s...

If you want me to keep making more videos like this, consider becoming my patron at Patreon: patreon.com/kb9rlw

Discuss this and other videos on Facebook:
facebook.com/kb9rlw

If you want to give me a tip, patreon donate page is here:
paypal.com/donate/?hosted_button_id=TJDA65P3JDVHJ
3D printing - Better bottom fillets with the Chamfillet techniqueHam Radio - My experimental 29:1 harmonic drive for magloops is finished.Short, but neat!  DJI Mini 2 in slow motion with sound.Electronics - Looking at the F-NIRSI LC1020E high precision LCR meter.Ham Radio - Replacing the backup battery in my HTX 2023D printing - Making 3D jigsaw puzzles with FreeCAD and InkscapeHam Radio - Viewer request. How to find the shorted connector on a coax jumper using the NanoVNA.VLOG short - The horse is back home and doing fine.New Hams Tips - What is the Noise Blanker used for?Ham Radio - Follow up and resolution on the IC 705 PL tone issue.Ham radio and 3D printing - Power Poles distribution block with USB chargerHam radio - Two ways to flash the firmware of the ATS mini si4732 receiver under linux.
Kevin Loughin |

3D printing - Better bottom fillets with the "Chamfillet" technique

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER