Ham radio and 3D printing - Power Poles distribution block with USB charger @loughkb
Ham radio and 3D printing - Power Poles distribution block with USB charger  @loughkb
Uploaded September 2024 | Updated November 2026, 3 hours ago
A much improved way of distributing power to the radios and devices at my desk. I didn't mention it in the video but I fused it at 15 amps.
As always, I make the files available for free at the link below.

Thing files:
thingiverse.com/thing:6755984

Fuse holder
amazon.com/dp/B00OK9H3EI?ref=ppx_yo2ov_dt_b_fed_asin_title

USB charger
amazon.com/dp/B0CY5PGB2S?ref=ppx_yo2ov_dt_b_fed_asin_title

Toroids
amazon.com/dp/B00W0HX3LO?ref=ppx_yo2ov_dt_b_fed_asin_title

If you like my videos, please subscribe here:
youtube.com/user/loughkb?sub_confirmation=1

If you want me to keep making more videos like this, consider becoming my patron at Patreon: patreon.com/kb9rlw

Discuss this and other videos on Facebook:
facebook.com/kb9rlw

If you want to give me a tip, patreon donate page is here:
paypal.com/donate/?hosted_button_id=TJDA65P3JDVHJ
Ham radio and 3D printing - Power Poles distribution block with USB chargerHam radio - Two ways to flash the firmware of the ATS mini si4732 receiver under linux.Electronics - Cheap parts. A cautionary tale!VLOG - Thoughts and updates for December 2024, Stuck for the Winter.Ham Radio - truSDX transmitted audio and signal quality in SSB, AM, and FM.Ham Radio - tr(u)SDX splatter problem, further testing.VLOG Where have I been the past two plus weeks?Ham Radio - Automate satellite capture with Gpredict and GQRX on Linux.Sound - Exploring sound in Audacity by stretching time.Ham Radio - Free and open source remote operation of many Icom radios with wfviewHam Radio experiment - End fed half wave antenna sloper vs flat horizontal orientation.Electronics - A look at the EIM tech zoolark and megoo portable test equipment.
Kevin Loughin |

Ham radio and 3D printing - Power Poles distribution block with USB charger

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER