Uploaded November 2011 | Updated November 2026, 3 hours ago
This Video shows my fist attempt at a machined magnesium cylinder ZnO/Mg cell. The electrolyte was Epsoms that was finely ground using a coffee grinder. Doping was accomplished at this point with Galina and Iron Pyrite. Addition of equal volume of ZnO and 1/3 volume CaCO3 and 1/8 volume Finely ground Silica Gel then the entire mixture was heated over the stove. A combined crumbly mix resulted. A minor amount of water was added to allow a paste formation to facilitate Graphite Rod insertion. Charging ensued while mix was still paste and HOT. This test was to have an equal thickness of electrolyte and mg wall. ANALOG METERS TO ENSURE NO FALSE DMM ISSUES. ALL THOUGHTS WELCOME.
Very Best Regards,
diveflyfish
This Video shows my fist attempt at a machined magnesium cylinder ZnO/Mg cell. The electrolyte was Epsoms that was finely ground using a coffee grinder. Doping was accomplished at this point with Galina and Iron Pyrite. Addition of equal volume of ZnO and 1/3 volume CaCO3 and 1/8 volume Finely ground Silica Gel then the entire mixture was heated over the stove. A combined crumbly mix resulted. A minor amount of water was added to allow a paste formation to facilitate Graphite Rod insertion. Charging ensued while mix was still paste and HOT. This test was to have an equal thickness of electrolyte and mg wall. ANALOG METERS TO ENSURE NO FALSE DMM ISSUES. ALL THOUGHTS WELCOME.
Very Best Regards,
diveflyfish










