Uploaded November 2013 | Updated November 2026, 8 hours ago
I almost finished my first real woodworkingbench, and decided to make a short video of the final step, making bench dogs.
It's a pretty simple way of making them. The top of the dogs is the same dimensions of the hole. The end of the dogs is a fraction wider. In my case 1.5mm more then the top. The cut passes about 1.5cm from the edge. 1cm was also fine, but i found the spring effect stronger and not to strong a little bit further.
I almost finished my first real woodworkingbench, and decided to make a short video of the final step, making bench dogs.
It's a pretty simple way of making them. The top of the dogs is the same dimensions of the hole. The end of the dogs is a fraction wider. In my case 1.5mm more then the top. The cut passes about 1.5cm from the edge. 1cm was also fine, but i found the spring effect stronger and not to strong a little bit further.










