As Wood Turns | Woodturning Three Part Goblet From Walnut and Hazelnut @AsWoodTurns | Uploaded 3 years ago | Updated 7 hours ago
https://www.AsWoodTurns.com
After I turned the goblet last week, one person asked if I could have salvaged the original or make it from multiple pieces. YES. Here we go.
This one is walnut from the cup and base; hazelnut for the stem. it is 2.5 inches by 7 inches finished with shellac.
I also used a 0.25" #2 Morse Taper collet to hold the spindle. Worked much better and safer than a Jacobs chuck.
BTW
#2 Morse Taper 0.25" Collet; Little Machine Shop #1747, about $11.95
Draw bar, 3/8" all thread; Hardware store
3/8" knob, DIY or purchase.
Enjoy!
Blog: https://www.AsWoodTurns.com
FB: https://www.Facebook.com/AsWoodTurns
InstaGram: http://www.Instgram.com/as_wood_turns
#goblet #woodGoblet #collet #woodworking #woodturning #woodturningprojects #lathe #AlanStratton #video #DIY
https://www.AsWoodTurns.com
After I turned the goblet last week, one person asked if I could have salvaged the original or make it from multiple pieces. YES. Here we go.
This one is walnut from the cup and base; hazelnut for the stem. it is 2.5 inches by 7 inches finished with shellac.
I also used a 0.25" #2 Morse Taper collet to hold the spindle. Worked much better and safer than a Jacobs chuck.
BTW
#2 Morse Taper 0.25" Collet; Little Machine Shop #1747, about $11.95
Draw bar, 3/8" all thread; Hardware store
3/8" knob, DIY or purchase.
Enjoy!
Blog: https://www.AsWoodTurns.com
FB: https://www.Facebook.com/AsWoodTurns
InstaGram: http://www.Instgram.com/as_wood_turns
#goblet #woodGoblet #collet #woodworking #woodturning #woodturningprojects #lathe #AlanStratton #video #DIY