Why Does This Welding Fixture Have 96 Holes? @FireballTool
Why Does This Welding Fixture Have 96 Holes?  @FireballTool
Uploaded August 2026 | Updated November 2026, 20 hours ago
Questions? Drop them in the comments or post on the Fireball forum.
https://fireball.discourse.group/t/new-fireball-double-riser-and-tooth-block/4094

A shorter, wider block gives you more usable table space...here's why. In this video I break down the new Fireball Tool double wide tooth block fixture and risers, compare it directly against the single row block, and show real setups where the single wide simply can't hold a part square.

The double wide uses a two-piece modular design: a tooth block chassis plus an interchangeable riser (3.5" or 13"), fastened from the bottom into a rigid 90° fixture. The 13" riser has 72 holes on its face for clamping and fixturing. Because the locating pins sit side by side instead of in line, you still get 2" of adjustment, but the block stays short, gaining you almost 3" of clearance behind it. That extra clearance is what lets you get into inside corners, run fixtures closer together, and work on a small welding table without blocks interfering with each other.

I also walk through holding a tube vertical and perpendicular at a set 15-5/8" offset, using a fence block with a 1-3/8" magnetic shim for a repeatable stop; the short adjustable tooth block with thick and thin offsets (and how to flip it for extra reach); the new double drag clamp that pushes back and down at the same time; what the two small holes next to the 3/4" hole are actually for (stacking a riser on a riser to make a shelf); using three-axis square pins in the side holes as a fence; and running Fireball square tabs with an 1/8" shim to square off the corner.

What's the difference between a single wide and double wide tooth block fixture?
Why does a shorter fixture block give you more clearance?
How do you hold a tube both vertical and perpendicular to a welding table?
How do you set a repeatable offset that isn't on the grid pattern?
What are the two small holes next to the 3/4" hole for?
Can you mount a riser onto another riser?
Which riser height should I buy... 4" or 13"?

Double wide tooth block fixture • 4" and 13" double wide risers • short adjustable tooth block • double drag clamp • magnetic shims • three-axis square pins • Fireball square tabs

#fireballtool #weldingtable #fabrication #welding #metalfabrication #weldingtips #machining #shopsetup

Get these tools and more at
Fireballtool.com
Why Does This Welding Fixture Have 96 Holes?STARSHIP OFFICE BUILD IN 10 MINUTESOur Starship Office Needs Desks!What Is A Welding Table Fixture Map?How I Built a Star Map for My Starship Office (7 of 9)The Day We Moved Into The Starship Office! Plus A Tour!How Fast Can a Belt Grinder Destroy a Ball Hitch?This New Table Design Is Crazy!Can this go-kart belt grinder run on a flat tire?The Fireball Miter Square VS The World!I Hired 15 Welders To Make The Same Thing. Heres What Happened.Cutting Glass For Our Starship Portal!
Fireball Tool |

Why Does This Welding Fixture Have 96 Holes?

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER