Uploaded May 2025 | Updated November 2026, 4 days ago
Testing the size limits of the Genmitsu Cubiko, I used a 6x4" piece of hard walnut and cut a 5x3.5" tray with a .35" deep pocket. I used the IDC Woodcraft downcut 1/8" bit. The pocket speeds were 40ipm with a .02" depth of cut and 40% stepover. The profile cut was 35ipm at the same depth. I played around with the feed rate during the job and was able to bump up the pocketing speeds to about 50ipm and still not have much chatter. The finish was pretty good with minimal sanding to clean up some of the transitions. Overall, the job took 1 hour and 44 minutes. Slow but good results for this tiny benchtop machine.
Check out the Cubiko at Sainsmart's website here: shrsl.com/4w4f6
Link to the IDC 1/8" Downcut endmill : idcwoodcraft.com/products/1-8-down-cut-endmill-bit-for-cnc-routers-1-8-shank
Become a channel member here:
youtube.com/channel/UC93sJsqzmDqkYrEHUPDQzuQ/join
#sainsmart #cnc #hobbycnc #genmitsu
@SainSmartofficial
@IDCWoodcraft
Testing the size limits of the Genmitsu Cubiko, I used a 6x4" piece of hard walnut and cut a 5x3.5" tray with a .35" deep pocket. I used the IDC Woodcraft downcut 1/8" bit. The pocket speeds were 40ipm with a .02" depth of cut and 40% stepover. The profile cut was 35ipm at the same depth. I played around with the feed rate during the job and was able to bump up the pocketing speeds to about 50ipm and still not have much chatter. The finish was pretty good with minimal sanding to clean up some of the transitions. Overall, the job took 1 hour and 44 minutes. Slow but good results for this tiny benchtop machine.
Check out the Cubiko at Sainsmart's website here: shrsl.com/4w4f6
Link to the IDC 1/8" Downcut endmill : idcwoodcraft.com/products/1-8-down-cut-endmill-bit-for-cnc-routers-1-8-shank
Become a channel member here:
youtube.com/channel/UC93sJsqzmDqkYrEHUPDQzuQ/join
#sainsmart #cnc #hobbycnc #genmitsu
@SainSmartofficial
@IDCWoodcraft










