Uploaded July 2019 | Updated November 2026, 3 days ago
➤Don't forget to subscribe ! bit.ly/SubscribeJMSpeedshop
➤Website: jmspeedshop.com
➤instagram: instagram.com/johanmuter
so got the OEM wring harness in the engine bay back in the car.
i did some mods to the harness. I removed all the wiring that is not need for the car anymore .
this wiring was for the engine controls of the old engine
like igniton and diagnostic wiring and stuff
so the loom now is only for the lighting and other AUX. controls
wiring like the engine temp for the dashboard and the oil level sensor is still from the old loom becuase these sensor are the same on the V12 . so this will be inlcuded back in the new engine loom .
also when i wanted to test the loom when it was back in the car to check if the light and everything else is still working . i connected everything like it should
but in this W201 there are seatbelts with a crash seatbelt protection system
i don't think all the cars have it but this 1984 car had this system
that is made By becker. same company as the radio's
this sytem is controlled by a small case that is under the dash on top of the transmission tunnel. and the get 12v direct from the fusebox but this power source is not running through a fuse.
so what happend is i put the car on ignition step 1 and i had an explosion on both sides in the B pilar where the seatbelts are located.
and the smell was like fireworks and smoke was coming from the B-pilar. so what happend . was for some reson the system is activated what normally only happends in a crash.
so i removed the seatbelts and can not be reset.
so i needed to by new seatbelts. and i removed the system because my opinion is that it is not save.
the seatbelts are locked in the position your in when having a crash and will not give and room after. so your stuck in the seatbelt. what is not save if you want to get out. i think
so lesson learned for me .
if there are any questions about this video just ask
JMSpeedshop.com
➤Don't forget to subscribe ! bit.ly/SubscribeJMSpeedshop
➤Website: jmspeedshop.com
➤instagram: instagram.com/johanmuter
so got the OEM wring harness in the engine bay back in the car.
i did some mods to the harness. I removed all the wiring that is not need for the car anymore .
this wiring was for the engine controls of the old engine
like igniton and diagnostic wiring and stuff
so the loom now is only for the lighting and other AUX. controls
wiring like the engine temp for the dashboard and the oil level sensor is still from the old loom becuase these sensor are the same on the V12 . so this will be inlcuded back in the new engine loom .
also when i wanted to test the loom when it was back in the car to check if the light and everything else is still working . i connected everything like it should
but in this W201 there are seatbelts with a crash seatbelt protection system
i don't think all the cars have it but this 1984 car had this system
that is made By becker. same company as the radio's
this sytem is controlled by a small case that is under the dash on top of the transmission tunnel. and the get 12v direct from the fusebox but this power source is not running through a fuse.
so what happend is i put the car on ignition step 1 and i had an explosion on both sides in the B pilar where the seatbelts are located.
and the smell was like fireworks and smoke was coming from the B-pilar. so what happend . was for some reson the system is activated what normally only happends in a crash.
so i removed the seatbelts and can not be reset.
so i needed to by new seatbelts. and i removed the system because my opinion is that it is not save.
the seatbelts are locked in the position your in when having a crash and will not give and room after. so your stuck in the seatbelt. what is not save if you want to get out. i think
so lesson learned for me .
if there are any questions about this video just ask
JMSpeedshop.com








![[ its very good ] Mercedes SLK 55 AMG Review & TestDrive JMSpeedshop !
➤Dont forget to subscribe ! http://bit.ly/SubscribeJMSpeedshop
➤Website: http://jmspeedshop.com
➤instagram: https://www.instagram.com/johanmuter/
this Video is al about the Mercedes SLK 55 AMG R171
Producing 360HP and 510 NM
Music Provided by NoCopyrightSounds:
Tubu - Hope https://youtu.be/EP625xQIGzs
this car was for sale at Passioncar.de this company is a specialist in rare youngtimers and classics or/and low mileage cars
here is a link to the website have a look for more nice cars
https://www.passioncar.de/
link to the car
https://www.passioncar.de/youngtimer/fahrzeug/mercedes-benz-slk-55-amg-mit-nur-45000km-1.html
this a pocket rocket. it is a small car with a big v8 the weight of the car may be arround 1540kg ready but it is still a short small car and that is making the handling very good
it is also the lighest v8 version of the m113 v8 era.
i can do 0-100 kph in around 4.9 sec
it is producing 360hp and 510nm . this model is delivered in a designo colort mystic white and in combination with the red black interior it is looking very nice.
this second generation is longer wider and has a bit more wheelbase lenght. that will give the inner room a bigger feeling and it is not feeling alot smaller then the r230 sl.
so if you want a pocket rocket with alot of luxury this is the one to get.
if there are some questions just ask [ its very good ] Mercedes SLK 55 AMG Review & TestDrive JMSpeedshop !](https://i.ytimg.com/vi/kpCL6It37Wc/mqdefault.jpg)

