Vote in the Toolpath Tiling Poll On My Community Tab @MarkLindsayCNC
Vote in the Toolpath Tiling Poll On My Community Tab  @MarkLindsayCNC
Uploaded June 2023 | Updated November 2026, 14 hours ago
I'm going to split the Toolpath Tiling series into 2 parts. Part 1 will be drawing the design, calculating the toolpaths, and saving the G-Code. Part 2 will be actually machining and finishing the project. The question is, should I release Part 1 as a recorded and edited video, with a normal Live Q&A later that same day? Or should I do the design work, calculate the toolpaths, and save G-Code during a live stream on a Sunday? This poll will run until Sunday, June 11th at Noon Pacific time, 3 pm Eastern time, and the results will be announced on that day's Live Q&A.

VOTE!!!

youtube.com/@MarkLindsayCNC/community

Check out StreamYard: streamyard.com/pal/d/5708919750000640
Vote in the Toolpath Tiling Poll On My Community TabLive Q&A #342 - Open Q&ALive Q&A #249 – Beginning and Intermediate Text Manipulation - Open Q&ALive Q&A #275 – Open Q&ALive Q&A #349 - Open Q&ALive Q&A #310 – Open Q&ALive Q&A #208 – Open Q&ALive Q&A #242 – My Major CNC Upgrade – Open Q&ALive Q&A #194 – Open Q&A - Vectric Program OptionsLive Q&A #337 - Open Q&ALive Q&A #269 – Open Q&ALive Q&A #256 – Vectric V12+ for the Absolute Beginner – Part 4
Mark Lindsay CNC |

Vote in the Toolpath Tiling Poll On My Community Tab

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER